From: "Radim Krčmář" <rkrcmar@redhat.com>
To: Paolo Bonzini <pbonzini@redhat.com>
Cc: linux-kernel@vger.kernel.org, kvm@vger.kernel.org,
bsd@redhat.com, guangrong.xiao@linux.intel.com,
Yang Zhang <yang.z.zhang@intel.com>,
wanpeng.li@linux.intel.com
Subject: Re: [RFC PATCH 00/13] KVM: x86: SMM support
Date: Tue, 5 May 2015 20:40:34 +0200 [thread overview]
Message-ID: <20150505184034.GA17718@potion.brq.redhat.com> (raw)
In-Reply-To: <1430393772-27208-1-git-send-email-pbonzini@redhat.com>
2015-04-30 13:35+0200, Paolo Bonzini:
> This patch series introduces system management mode support.
> There is still some work to do, namely: test without unrestricted
> guest support, test on AMD, disable the capability if !unrestricted
> guest and !emulate invalid guest state(*), test with a QEMU that
> understand KVM_MEM_X86_SMRAM, actually post QEMU patches that let
> you use this.
>
> (*) newer chipsets moved away from legacy SMRAM at 0xa0000,
> thus support for real mode CS base above 1M is necessary
>
> Because legacy SMRAM is a mess, I have tried these patches with Q35's
> high SMRAM (at 0xfeda0000). This means that right now this isn't
> the easiest thing to test; you need QEMU patches that add support
> for high SMRAM, and SeaBIOS patches to use high SMRAM. Until QEMU
> support for KVM_MEM_X86_SMRAM is in place, also, I'm keeping SMRAM
> open in SeaBIOS.
>
> That said, even this clumsy and incomplete userspace configuration is
> enough to test all patches except 11 and 12.
>
> The series is structured as follows.
>
> Patch 1 is an unrelated bugfix (I think). Patches 2 to 6 extend some
> infrastructure functions. Patches 1 to 4 could be committed right now.
>
> Patches 7 to 9 implement basic support for SMM in the KVM API
> and teach KVM about doing the world switch on SMI and RSM.
>
> Patch 10 touches all places in KVM that read/write guest memory to
> go through an x86-specific function. The x86-specific function takes
> a VCPU rather than a struct kvm. This is used in patches 11 and 12
> to limits access to specially marked SMRAM slots unless the VCPU is
> in system management mode.
>
> Finally, patch 13 exposes the new capability for userspace to probe.
I lost all concentration, so I'll write down design problems I noticed
while reviewing till now in case it helps:
(haven't mentioned the first three yet.)
- Whole SMRAM is writeable. Spec says that parts of state should be
read-only. (This seems hard to fix without trapping all writes.)
- I/O restarting is not enabled. (APM 2:10.2.4 SMM-Revision Identifier
says that AMD64 always sets this bit.)
- NMI handling has some quirks. (Software can enable NMI and another
SMI should mask them again.)
- SMIs received while in SMM aren't handled. (One can be pending.)
- SMM and userspace.
We can get if smm is enabled at two separate places (flag from KVM_RUN
and in KVM_GET_VCPU_EVENTS) and toggle it via KVM_SET_VCPU_EVENTS.
It's not an event, so I wouldn't include it in EVENTS API ...
Letting the flag in KVM_RUN also toggle SMM would be easiest.
Otherwise, wouldn't GET/SET_ONE_REG be a better match for it?
- [10/13] :)
next prev parent reply other threads:[~2015-05-05 18:41 UTC|newest]
Thread overview: 54+ messages / expand[flat|nested] mbox.gz Atom feed top
2015-04-30 11:35 Paolo Bonzini
2015-04-30 11:36 ` [PATCH 01/13] KVM: MMU: fix for CR4.SMEP=1, CR0.WP=0? Paolo Bonzini
2015-05-08 2:52 ` Xiao Guangrong
2015-04-30 11:36 ` [PATCH 02/13] KVM: reuse memslot in kvm_write_guest_page Paolo Bonzini
2015-05-05 15:03 ` Bandan Das
2015-05-05 16:29 ` Radim Krčmář
2015-04-30 11:36 ` [PATCH 03/13] KVM: export __gfn_to_pfn_memslot, drop gfn_to_pfn_async Paolo Bonzini
2015-04-30 11:36 ` [PATCH 04/13] KVM: remove unnecessary arg from mark_page_dirty_in_slot, export it Paolo Bonzini
2015-04-30 11:36 ` [PATCH 05/13] KVM: x86: pass host_initiated to functions that read MSRs Paolo Bonzini
2015-05-04 14:01 ` Radim Krčmář
2015-05-04 16:04 ` Paolo Bonzini
2015-04-30 11:36 ` [PATCH 06/13] KVM: x86: pass the whole hflags field to emulator and back Paolo Bonzini
2015-05-05 15:47 ` Bandan Das
2015-05-05 16:16 ` Paolo Bonzini
2015-05-06 16:49 ` Bandan Das
2015-04-30 11:36 ` [PATCH 07/13] KVM: x86: API changes for SMM support Paolo Bonzini
2015-05-04 15:37 ` Radim Krčmář
2015-05-04 16:02 ` Paolo Bonzini
2015-05-05 16:36 ` Bandan Das
2015-05-05 16:45 ` Paolo Bonzini
2015-04-30 11:36 ` [PATCH 08/13] KVM: x86: stubs " Paolo Bonzini
2015-05-04 17:51 ` Radim Krčmář
2015-05-05 9:37 ` Paolo Bonzini
2015-05-05 18:38 ` Bandan Das
2015-05-05 18:48 ` Radim Krčmář
2015-04-30 11:36 ` [PATCH 09/13] KVM: x86: save/load state on SMM switch Paolo Bonzini
2015-05-04 19:59 ` Radim Krčmář
2015-05-05 9:37 ` Paolo Bonzini
2015-05-05 12:48 ` Radim Krčmář
2015-05-05 13:18 ` Paolo Bonzini
2015-05-05 20:44 ` Bandan Das
2015-05-06 10:39 ` Paolo Bonzini
2015-05-06 17:55 ` Bandan Das
2015-05-06 19:38 ` Paolo Bonzini
2015-05-12 23:56 ` Bandan Das
2015-05-13 6:58 ` Paolo Bonzini
2015-04-30 11:36 ` [PATCH 10/13] KVM: x86: add vcpu-specific functions to read/write/translate GFNs Paolo Bonzini
2015-04-30 11:36 ` [PATCH 11/13] KVM: x86: add SMM to the MMU role Paolo Bonzini
2015-04-30 11:36 ` [PATCH 12/13] KVM: x86: add KVM_MEM_X86_SMRAM memory slot flag Paolo Bonzini
2015-05-05 17:17 ` Radim Krčmář
2015-05-06 9:47 ` Paolo Bonzini
2015-05-06 16:24 ` Radim Krčmář
2015-05-06 18:15 ` Bandan Das
2015-05-06 19:43 ` Paolo Bonzini
2015-05-15 20:32 ` Avi Kivity
2015-05-18 8:31 ` Paolo Bonzini
2015-04-30 11:36 ` [PATCH 13/13] KVM: x86: advertise KVM_CAP_X86_SMM Paolo Bonzini
2015-05-05 18:40 ` Radim Krčmář [this message]
2015-05-06 11:18 ` [RFC PATCH 00/13] KVM: x86: SMM support Paolo Bonzini
2015-05-06 17:14 ` Radim Krčmář
2015-05-19 14:25 ` Zhang, Yang Z
2015-05-19 14:27 ` Paolo Bonzini
2015-05-20 1:03 ` Zhang, Yang Z
2015-05-20 15:22 ` Andi Kleen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20150505184034.GA17718@potion.brq.redhat.com \
--to=rkrcmar@redhat.com \
--cc=bsd@redhat.com \
--cc=guangrong.xiao@linux.intel.com \
--cc=kvm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=pbonzini@redhat.com \
--cc=wanpeng.li@linux.intel.com \
--cc=yang.z.zhang@intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
Powered by JetHome