Re: [PATCH] mmc: sdhci-bcm2835: Actually enable the clock

[Russell King - ARM Linux <linux@arm.linux.org.uk>]

On Thu, May 28, 2015 at 05:03:12PM -0700, Eric Anholt wrote:
> We're currently using a fixed frequency clock specified in the DT, so
> enabling is a no-op.  However, the RPi firmware-based clocks driver
> can actually disable unused clocks, so when switching to use it we
> ended up losing our MMC clock once all devices were probed.
> 
> Signed-off-by: Eric Anholt <eric@anholt.net>
> ---
>  drivers/mmc/host/sdhci-bcm2835.c | 5 +++++
>  1 file changed, 5 insertions(+)
> 
> diff --git a/drivers/mmc/host/sdhci-bcm2835.c b/drivers/mmc/host/sdhci-bcm2835.c
> index 0ef0343..09aff3a 100644
> --- a/drivers/mmc/host/sdhci-bcm2835.c
> +++ b/drivers/mmc/host/sdhci-bcm2835.c
> @@ -172,6 +172,11 @@ static int bcm2835_sdhci_probe(struct platform_device *pdev)
>  		ret = PTR_ERR(pltfm_host->clk);
>  		goto err;
>  	}
> +	ret = clk_prepare_enable(pltfm_host->clk);
> +	if (ret) {
> +		dev_err(&pdev->dev, "failed to enable host clk\n");
> +		goto err;
> +	}
>  
>  	return sdhci_add_host(host);

Where's the error clean-up path for a failed sdhci_add_host()?

-- 
FTTC broadband for 0.8mile line: currently at 10.5Mbps down 400kbps up
according to speedtest.net.