[PATCH 5/7] staging: dgnc: remove useless variable 'ch_intr_modem'

[PATCH 5/7] staging: dgnc: remove useless variable 'ch_intr_modem'

[Daeseok Youn]

The 'ch_intr_modem' variable was used only for increasing.
So the 'ch_intr_modem' variable is not useful for this driver.

Signed-off-by: Daeseok Youn <daeseok.youn@gmail.com>
---
 drivers/staging/dgnc/dgnc_cls.c    | 9 ---------
 drivers/staging/dgnc/dgnc_driver.h | 1 -
 drivers/staging/dgnc/dgnc_neo.c    | 1 -
 3 files changed, 11 deletions(-)

diff --git a/drivers/staging/dgnc/dgnc_cls.c b/drivers/staging/dgnc/dgnc_cls.c
index 35526f8..d7ff5fa 100644
--- a/drivers/staging/dgnc/dgnc_cls.c
+++ b/drivers/staging/dgnc/dgnc_cls.c
@@ -402,15 +402,6 @@ static inline void cls_parse_isr(struct dgnc_board *brd, uint port)
 			cls_copy_data_from_queue_to_uart(ch);
 		}
 
-		/* CTS/RTS change of state */
-		if (isr & UART_IIR_CTSRTS) {
-			ch->ch_intr_modem++;
-			/*
-			 * Don't need to do anything, the cls_parse_modem
-			 * below will grab the updated modem signals.
-			 */
-		}
-
 		/* Parse any modem signal changes */
 		cls_parse_modem(ch, readb(&ch->ch_cls_uart->msr));
 	}
diff --git a/drivers/staging/dgnc/dgnc_driver.h b/drivers/staging/dgnc/dgnc_driver.h
index 914130d..1063388 100644
--- a/drivers/staging/dgnc/dgnc_driver.h
+++ b/drivers/staging/dgnc/dgnc_driver.h
@@ -377,7 +377,6 @@ struct channel_t {
 	ulong		ch_xon_sends;	/* Count of xons transmitted */
 	ulong		ch_xoff_sends;	/* Count of xoffs transmitted */
 
-	ulong		ch_intr_modem;	/* Count of interrupts */
 	ulong		ch_intr_tx;	/* Count of interrupts */
 	ulong		ch_intr_rx;	/* Count of interrupts */
 
diff --git a/drivers/staging/dgnc/dgnc_neo.c b/drivers/staging/dgnc/dgnc_neo.c
index f99c0db..9b3264c 100644
--- a/drivers/staging/dgnc/dgnc_neo.c
+++ b/drivers/staging/dgnc/dgnc_neo.c
@@ -450,7 +450,6 @@ static inline void neo_parse_isr(struct dgnc_board *brd, uint port)
 			 * If we get here, this means the hardware is doing auto flow control.
 			 * Check to see whether RTS/DTR or CTS/DSR caused this interrupt.
 			 */
-			ch->ch_intr_modem++;
 			cause = readb(&ch->ch_neo_uart->mcr);
 			/* Which pin is doing auto flow? RTS or DTR? */
 			if ((cause & 0x4) == 0) {
-- 
1.9.1