[PATCH 0185/1285] Replace numeric parameter like 0444 with macro

[PATCH 0185/1285] Replace numeric parameter like 0444 with macro

[Baole Ni]

I find that the developers often just specified the numeric value
when calling a macro which is defined with a parameter for access permission.
As we know, these numeric value for access permission have had the corresponding macro,
and that using macro can improve the robustness and readability of the code,
thus, I suggest replacing the numeric parameter with the macro.

Signed-off-by: Chuansheng Liu <chuansheng.liu@intel.com>
Signed-off-by: Baole Ni <baolex.ni@intel.com>
---
 drivers/gpu/drm/drm_dp_helper.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/drm_dp_helper.c b/drivers/gpu/drm/drm_dp_helper.c
index eeaf5a7..694afc6 100644
--- a/drivers/gpu/drm/drm_dp_helper.c
+++ b/drivers/gpu/drm/drm_dp_helper.c
@@ -543,7 +543,7 @@ static int drm_dp_i2c_retry_count(const struct drm_dp_aux_msg *msg,
  * to require it. We should query/set the speed via DPCD if supported.
  */
 static int dp_aux_i2c_speed_khz __read_mostly = 10;
-module_param_unsafe(dp_aux_i2c_speed_khz, int, 0644);
+module_param_unsafe(dp_aux_i2c_speed_khz, int, S_IRUSR | S_IWUSR | S_IRGRP | S_IROTH);
 MODULE_PARM_DESC(dp_aux_i2c_speed_khz,
 		 "Assumed speed of the i2c bus in kHz, (1-400, default 10)");
 
@@ -691,7 +691,7 @@ static int drm_dp_i2c_drain_msg(struct drm_dp_aux *aux, struct drm_dp_aux_msg *o
  * succeed. Hence the default is maximum.
  */
 static int dp_aux_i2c_transfer_size __read_mostly = DP_AUX_MAX_PAYLOAD_BYTES;
-module_param_unsafe(dp_aux_i2c_transfer_size, int, 0644);
+module_param_unsafe(dp_aux_i2c_transfer_size, int, S_IRUSR | S_IWUSR | S_IRGRP | S_IROTH);
 MODULE_PARM_DESC(dp_aux_i2c_transfer_size,
 		 "Number of bytes to transfer in a single I2C over DP AUX CH message, (1-16, default 16)");
 
-- 
2.9.2