From: John Keeping <john@metanate.com>
To: Mark Yao <mark.yao@rock-chips.com>
Cc: Chris Zhong <zyw@rock-chips.com>,
dri-devel@lists.freedesktop.org,
linux-arm-kernel@lists.infradead.org,
linux-rockchip@lists.infradead.org, linux-kernel@vger.kernel.org,
John Keeping <john@metanate.com>
Subject: [PATCH v2 26/26] drm/rockchip: dw-mipi-dsi: support read commands
Date: Sat, 21 Jan 2017 16:31:28 +0000 [thread overview]
Message-ID: <20170121163128.22240-27-john@metanate.com> (raw)
In-Reply-To: <20170121163128.22240-1-john@metanate.com>
I haven't found any method for getting the length of a response, so this
just uses the requested rx_len
Signed-off-by: John Keeping <john@metanate.com>
---
Unchanged in v2
---
drivers/gpu/drm/rockchip/dw-mipi-dsi.c | 54 ++++++++++++++++++++++++++++++++++
1 file changed, 54 insertions(+)
diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
index f780401e8b5e..f0cb005c6d76 100644
--- a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
+++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
@@ -675,6 +675,54 @@ static int dw_mipi_dsi_dcs_long_write(struct dw_mipi_dsi *dsi,
return dw_mipi_dsi_gen_pkt_hdr_write(dsi, hdr_val);
}
+static int dw_mipi_dsi_dcs_read(struct dw_mipi_dsi *dsi,
+ const struct mipi_dsi_msg *msg)
+{
+ const u8 *tx_buf = msg->tx_buf;
+ u8 *rx_buf = msg->rx_buf;
+ size_t i;
+ int ret, val;
+
+ dsi_write(dsi, DSI_PCKHDL_CFG, EN_CRC_RX | EN_ECC_RX | EN_BTA);
+ dsi_write(dsi, DSI_GEN_HDR, GEN_HDATA(tx_buf[0]) | GEN_HTYPE(msg->type));
+
+ ret = readl_poll_timeout(dsi->base + DSI_CMD_PKT_STATUS,
+ val, !(val & GEN_RD_CMD_BUSY), 1000,
+ CMD_PKT_STATUS_TIMEOUT_US);
+ if (ret < 0) {
+ dev_err(dsi->dev, "failed to read command response\n");
+ return ret;
+ }
+
+ for (i = 0; i < msg->rx_len;) {
+ u32 pld = dsi_read(dsi, DSI_GEN_PLD_DATA);
+ while (i < msg->rx_len) {
+ rx_buf[i] = pld & 0xff;
+ pld >>= 8;
+ i++;
+ }
+ }
+
+ return msg->rx_len;
+}
+
+static int dw_mipi_dsi_set_max_return_packet_size(struct dw_mipi_dsi *dsi,
+ size_t len)
+{
+ u8 val[] = { len & 0xff, (len >> 8) & 0xff };
+ struct mipi_dsi_msg msg = {
+ .channel = dsi->channel,
+ .type = MIPI_DSI_SET_MAXIMUM_RETURN_PACKET_SIZE,
+ .tx_buf = val,
+ .tx_len = 2,
+ };
+
+ if (len > 0xffff)
+ return -EINVAL;
+
+ return dw_mipi_dsi_dcs_short_write(dsi, &msg);
+}
+
static ssize_t dw_mipi_dsi_host_transfer(struct mipi_dsi_host *host,
const struct mipi_dsi_msg *msg)
{
@@ -692,6 +740,12 @@ static ssize_t dw_mipi_dsi_host_transfer(struct mipi_dsi_host *host,
case MIPI_DSI_DCS_LONG_WRITE:
ret = dw_mipi_dsi_dcs_long_write(dsi, msg);
break;
+ case MIPI_DSI_DCS_READ:
+ ret = dw_mipi_dsi_set_max_return_packet_size(dsi, msg->rx_len);
+ if (ret < 0)
+ return ret;
+ ret = dw_mipi_dsi_dcs_read(dsi, msg);
+ break;
default:
dev_err(dsi->dev, "unsupported message type 0x%02x\n",
msg->type);
--
2.11.0.197.gb556de5.dirty
next prev parent reply other threads:[~2017-01-21 16:37 UTC|newest]
Thread overview: 50+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-01-21 16:31 [PATCH v2 00/26] drm/rockchip: MIPI fixes & improvements John Keeping
2017-01-21 16:31 ` [PATCH v2 01/26] drm/rockchip: dw-mipi-dsi: don't configure hardware in mode_set for MIPI John Keeping
2017-01-22 3:58 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 02/26] drm/rockchip: dw-mipi-dsi: rename commit hook to enable John Keeping
2017-01-21 16:31 ` [PATCH v2 03/26] drm/rockchip: dw-mipi-dsi: pass mode in where needed John Keeping
2017-01-22 4:00 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 04/26] drm/rockchip: dw-mipi-dsi: remove mode_set hook John Keeping
2017-01-22 6:08 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 05/26] drm/rockchip: dw-mipi-dsi: fix command header writes John Keeping
2017-01-21 16:31 ` [PATCH v2 06/26] drm/rockchip: dw-mipi-dsi: fix generic packet status check John Keeping
2017-01-22 6:24 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 07/26] drm/rockchip: dw-mipi-dsi: avoid out-of-bounds read on tx_buf John Keeping
2017-01-22 6:42 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 08/26] drm/rockchip: dw-mipi-dsi: include bad value in error message John Keeping
2017-01-22 6:44 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 09/26] drm/rockchip: dw-mipi-dsi: respect message flags John Keeping
2017-01-22 7:14 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 10/26] drm/rockchip: dw-mipi-dsi: only request HS clock when required John Keeping
2017-01-22 8:10 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 11/26] drm/rockchip: dw-mipi-dsi: don't assume buffer is aligned John Keeping
2017-01-22 8:16 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 12/26] drm/rockchip: dw-mipi-dsi: prepare panel after phy init John Keeping
2017-01-22 8:22 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 13/26] drm/rockchip: dw-mipi-dsi: allow commands in panel_disable John Keeping
2017-01-22 8:37 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 14/26] drm/rockchip: dw-mipi-dsi: fix escape clock rate John Keeping
2017-01-22 9:37 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 15/26] drm/rockchip: dw-mipi-dsi: ensure PHY is reset John Keeping
2017-01-22 9:37 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 16/26] drm/rockchip: dw-mipi-dsi: configure bias and bandgap before enable John Keeping
2017-01-21 16:31 ` [PATCH v2 17/26] drm/rockchip: dw-mipi-dsi: don't enable PHY PLL until it's configured John Keeping
2017-01-22 10:07 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 18/26] drm/rockchip: dw-mipi-dsi: properly configure PHY timing John Keeping
2017-01-22 3:06 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 19/26] drm/rockchip: dw-mipi-dsi: improve PLL configuration John Keeping
2017-01-23 1:38 ` Chris Zhong
2017-01-23 12:49 ` John Keeping
2017-01-24 2:42 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 20/26] drm/rockchip: dw-mipi-dsi: use specific poll helper John Keeping
2017-01-23 0:49 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 21/26] drm/rockchip: dw-mipi-dsi: use positive check for N{H,V}SYNC John Keeping
2017-01-21 16:31 ` [PATCH v2 22/26] drm/rockchip: vop: test for P{H,V}SYNC John Keeping
2017-01-23 7:12 ` Mark yao
2017-01-21 16:31 ` [PATCH v2 23/26] drm/rockchip: dw-mipi-dsi: defer probe if panel is not loaded John Keeping
2017-01-21 16:31 ` [PATCH v2 24/26] drm/rockchip: dw-mipi-dsi: support non-burst modes John Keeping
2017-01-23 6:11 ` Chris Zhong
2017-01-21 16:31 ` [PATCH v2 25/26] drm/rockchip: dw-mipi-dsi: add reset control John Keeping
2017-01-23 6:12 ` Chris Zhong
2017-01-21 16:31 ` John Keeping [this message]
2017-01-22 3:08 ` [PATCH v2 26/26] drm/rockchip: dw-mipi-dsi: support read commands Chris Zhong
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20170121163128.22240-27-john@metanate.com \
--to=john@metanate.com \
--cc=dri-devel@lists.freedesktop.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rockchip@lists.infradead.org \
--cc=mark.yao@rock-chips.com \
--cc=zyw@rock-chips.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
Powered by JetHome