From: John Keeping <john@metanate.com>
To: Mark Yao <mark.yao@rock-chips.com>
Cc: Chris Zhong <zyw@rock-chips.com>,
dri-devel@lists.freedesktop.org,
linux-arm-kernel@lists.infradead.org,
linux-rockchip@lists.infradead.org, linux-kernel@vger.kernel.org,
Sean Paul <seanpaul@chromium.org>,
John Keeping <john@metanate.com>
Subject: [PATCH v4 23/23] drm/rockchip: dw-mipi-dsi: add reset control
Date: Fri, 24 Feb 2017 12:55:06 +0000 [thread overview]
Message-ID: <20170224125506.21533-24-john@metanate.com> (raw)
In-Reply-To: <20170224125506.21533-1-john@metanate.com>
In order to fully reset the state of the MIPI controller we must assert
this reset.
This is slightly more complicated than it could be in order to maintain
compatibility with device trees that do not specify the reset property.
Signed-off-by: John Keeping <john@metanate.com>
Reviewed-by: Chris Zhong <zyw@rock-chips.com>
---
v4:
- Fix error check for devm_reset_control_get() to use ENOENT
v3:
- Add Chris' Reviewed-by
Unchanged in v2
---
drivers/gpu/drm/rockchip/dw-mipi-dsi.c | 31 +++++++++++++++++++++++++++++++
1 file changed, 31 insertions(+)
diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
index 0c4bae711e84..30da75667334 100644
--- a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
+++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
@@ -13,6 +13,7 @@
#include <linux/module.h>
#include <linux/of_device.h>
#include <linux/regmap.h>
+#include <linux/reset.h>
#include <linux/mfd/syscon.h>
#include <drm/drm_atomic_helper.h>
#include <drm/drm_crtc.h>
@@ -1144,6 +1145,7 @@ static int dw_mipi_dsi_bind(struct device *dev, struct device *master,
of_match_device(dw_mipi_dsi_dt_ids, dev);
const struct dw_mipi_dsi_plat_data *pdata = of_id->data;
struct platform_device *pdev = to_platform_device(dev);
+ struct reset_control *apb_rst;
struct drm_device *drm = data;
struct dw_mipi_dsi *dsi;
struct resource *res;
@@ -1182,6 +1184,35 @@ static int dw_mipi_dsi_bind(struct device *dev, struct device *master,
return ret;
}
+ /*
+ * Note that the reset was not defined in the initial device tree, so
+ * we have to be prepared for it not being found.
+ */
+ apb_rst = devm_reset_control_get(dev, "apb");
+ if (IS_ERR(apb_rst)) {
+ ret = PTR_ERR(apb_rst);
+ if (ret == -ENOENT) {
+ apb_rst = NULL;
+ } else {
+ dev_err(dev, "Unable to get reset control: %d\n", ret);
+ return ret;
+ }
+ }
+
+ if (apb_rst) {
+ ret = clk_prepare_enable(dsi->pclk);
+ if (ret) {
+ dev_err(dev, "%s: Failed to enable pclk\n", __func__);
+ return ret;
+ }
+
+ reset_control_assert(apb_rst);
+ usleep_range(10, 20);
+ reset_control_deassert(apb_rst);
+
+ clk_disable_unprepare(dsi->pclk);
+ }
+
ret = clk_prepare_enable(dsi->pllref_clk);
if (ret) {
dev_err(dev, "%s: Failed to enable pllref_clk\n", __func__);
--
2.12.0.rc0.230.gf625d4cdb9.dirty
next prev parent reply other threads:[~2017-02-24 12:59 UTC|newest]
Thread overview: 35+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-02-24 12:54 [PATCH v4 00/23] drm/rockchip: MIPI fixes & improvements John Keeping
2017-02-24 12:54 ` [PATCH v4 01/23] drm/rockchip: dw-mipi-dsi: don't configure hardware in mode_set for MIPI John Keeping
2017-02-24 12:54 ` [PATCH v4 02/23] drm/rockchip: dw-mipi-dsi: pass mode in where needed John Keeping
2017-02-24 12:54 ` [PATCH v4 03/23] drm/rockchip: dw-mipi-dsi: remove mode_set hook John Keeping
2017-02-24 12:54 ` [PATCH v4 04/23] drm/rockchip: dw-mipi-dsi: fix command header writes John Keeping
2017-02-24 12:54 ` [PATCH v4 05/23] drm/rockchip: dw-mipi-dsi: fix generic packet status check John Keeping
2017-02-24 12:54 ` [PATCH v4 06/23] drm/rockchip: dw-mipi-dsi: avoid out-of-bounds read on tx_buf John Keeping
2017-02-24 12:54 ` [PATCH v4 07/23] drm/rockchip: dw-mipi-dsi: include bad value in error message John Keeping
2017-02-24 12:54 ` [PATCH v4 08/23] drm/rockchip: dw-mipi-dsi: respect message flags John Keeping
2017-02-24 12:54 ` [PATCH v4 09/23] drm/rockchip: dw-mipi-dsi: only request HS clock when required John Keeping
2017-02-24 12:54 ` [PATCH v4 10/23] drm/rockchip: dw-mipi-dsi: don't assume buffer is aligned John Keeping
2017-02-24 12:54 ` [PATCH v4 11/23] drm/rockchip: dw-mipi-dsi: prepare panel after phy init John Keeping
2017-02-24 12:54 ` [PATCH v4 12/23] drm/rockchip: dw-mipi-dsi: allow commands in panel_disable John Keeping
2017-02-24 12:54 ` [PATCH v4 13/23] drm/rockchip: dw-mipi-dsi: fix escape clock rate John Keeping
2017-02-24 12:54 ` [PATCH v4 14/23] drm/rockchip: dw-mipi-dsi: ensure PHY is reset John Keeping
2017-02-24 12:54 ` [PATCH v4 15/23] drm/rockchip: dw-mipi-dsi: configure PHY before enabling John Keeping
2017-02-24 12:54 ` [PATCH v4 16/23] drm/rockchip: dw-mipi-dsi: properly configure PHY timing John Keeping
2017-02-24 12:55 ` [PATCH v4 17/23] drm/rockchip: dw-mipi-dsi: improve PLL configuration John Keeping
2017-02-24 12:55 ` [PATCH v4 18/23] drm/rockchip: dw-mipi-dsi: use specific poll helper John Keeping
2017-02-24 12:55 ` [PATCH v4 19/23] drm/rockchip: dw-mipi-dsi: use positive check for N{H,V}SYNC John Keeping
2017-02-24 12:55 ` [PATCH v4 20/23] drm/rockchip: vop: test for P{H,V}SYNC John Keeping
2017-02-24 12:55 ` [PATCH v4 21/23] drm/rockchip: dw-mipi-dsi: defer probe if panel is not loaded John Keeping
2017-02-24 12:55 ` [PATCH v4 22/23] drm/rockchip: dw-mipi-dsi: support non-burst modes John Keeping
2017-02-24 12:55 ` John Keeping [this message]
2017-03-02 21:56 ` [PATCH v4 23/23] drm/rockchip: dw-mipi-dsi: add reset control Brian Norris
2017-03-03 11:39 ` [PATCH] dt-bindings: display: rk3288-mipi-dsi: add reset property John Keeping
2017-03-03 20:41 ` Brian Norris
2017-03-06 16:52 ` Sean Paul
2017-03-12 12:06 ` Rob Herring
2017-04-04 13:15 ` John Keeping
2017-04-04 18:30 ` Sean Paul
2017-03-02 21:59 ` [PATCH v4 23/23] drm/rockchip: dw-mipi-dsi: add reset control Brian Norris
2017-02-27 1:41 ` [PATCH v4 00/23] drm/rockchip: MIPI fixes & improvements Mark yao
2017-02-27 3:34 ` Chris Zhong
2017-03-01 20:03 ` Sean Paul
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20170224125506.21533-24-john@metanate.com \
--to=john@metanate.com \
--cc=dri-devel@lists.freedesktop.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rockchip@lists.infradead.org \
--cc=mark.yao@rock-chips.com \
--cc=seanpaul@chromium.org \
--cc=zyw@rock-chips.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®