mirror of https://lore.kernel.org/lkml/
 help / color / mirror / Atom feed
From: John Keeping <john@metanate.com>
To: Mark Yao <mark.yao@rock-chips.com>
Cc: Chris Zhong <zyw@rock-chips.com>,
	dri-devel@lists.freedesktop.org,
	linux-arm-kernel@lists.infradead.org,
	linux-rockchip@lists.infradead.org, linux-kernel@vger.kernel.org,
	Sean Paul <seanpaul@chromium.org>,
	John Keeping <john@metanate.com>
Subject: [PATCH v4 06/23] drm/rockchip: dw-mipi-dsi: avoid out-of-bounds read on tx_buf
Date: Fri, 24 Feb 2017 12:54:49 +0000	[thread overview]
Message-ID: <20170224125506.21533-7-john@metanate.com> (raw)
In-Reply-To: <20170224125506.21533-1-john@metanate.com>

As a side-effect of this, encode the endianness explicitly rather than
casting a u16.

Signed-off-by: John Keeping <john@metanate.com>
---
v4:
- Introduce "data" variable to avoid confusion around the masking in
  GEN_HDATA()
v3:
- Add Chris' Reviewed-by
Unchanged in v2
---
 drivers/gpu/drm/rockchip/dw-mipi-dsi.c | 11 +++++++++--
 1 file changed, 9 insertions(+), 2 deletions(-)

diff --git a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
index 4be1ff3a42bb..f55010312f25 100644
--- a/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
+++ b/drivers/gpu/drm/rockchip/dw-mipi-dsi.c
@@ -572,8 +572,14 @@ static int dw_mipi_dsi_gen_pkt_hdr_write(struct dw_mipi_dsi *dsi, u32 hdr_val)
 static int dw_mipi_dsi_dcs_short_write(struct dw_mipi_dsi *dsi,
 				       const struct mipi_dsi_msg *msg)
 {
-	const u16 *tx_buf = msg->tx_buf;
-	u32 val = GEN_HDATA(*tx_buf) | GEN_HTYPE(msg->type);
+	const u8 *tx_buf = msg->tx_buf;
+	u16 data = 0;
+	u32 val;
+
+	if (msg->tx_len > 0)
+		data |= tx_buf[0];
+	if (msg->tx_len > 1)
+		data |= tx_buf[1] << 8;
 
 	if (msg->tx_len > 2) {
 		dev_err(dsi->dev, "too long tx buf length %zu for short write\n",
@@ -581,6 +587,7 @@ static int dw_mipi_dsi_dcs_short_write(struct dw_mipi_dsi *dsi,
 		return -EINVAL;
 	}
 
+	val = GEN_HDATA(data) | GEN_HTYPE(msg->type);
 	return dw_mipi_dsi_gen_pkt_hdr_write(dsi, val);
 }
 
-- 
2.12.0.rc0.230.gf625d4cdb9.dirty

  parent reply	other threads:[~2017-02-24 12:56 UTC|newest]

Thread overview: 35+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2017-02-24 12:54 [PATCH v4 00/23] drm/rockchip: MIPI fixes & improvements John Keeping
2017-02-24 12:54 ` [PATCH v4 01/23] drm/rockchip: dw-mipi-dsi: don't configure hardware in mode_set for MIPI John Keeping
2017-02-24 12:54 ` [PATCH v4 02/23] drm/rockchip: dw-mipi-dsi: pass mode in where needed John Keeping
2017-02-24 12:54 ` [PATCH v4 03/23] drm/rockchip: dw-mipi-dsi: remove mode_set hook John Keeping
2017-02-24 12:54 ` [PATCH v4 04/23] drm/rockchip: dw-mipi-dsi: fix command header writes John Keeping
2017-02-24 12:54 ` [PATCH v4 05/23] drm/rockchip: dw-mipi-dsi: fix generic packet status check John Keeping
2017-02-24 12:54 ` John Keeping [this message]
2017-02-24 12:54 ` [PATCH v4 07/23] drm/rockchip: dw-mipi-dsi: include bad value in error message John Keeping
2017-02-24 12:54 ` [PATCH v4 08/23] drm/rockchip: dw-mipi-dsi: respect message flags John Keeping
2017-02-24 12:54 ` [PATCH v4 09/23] drm/rockchip: dw-mipi-dsi: only request HS clock when required John Keeping
2017-02-24 12:54 ` [PATCH v4 10/23] drm/rockchip: dw-mipi-dsi: don't assume buffer is aligned John Keeping
2017-02-24 12:54 ` [PATCH v4 11/23] drm/rockchip: dw-mipi-dsi: prepare panel after phy init John Keeping
2017-02-24 12:54 ` [PATCH v4 12/23] drm/rockchip: dw-mipi-dsi: allow commands in panel_disable John Keeping
2017-02-24 12:54 ` [PATCH v4 13/23] drm/rockchip: dw-mipi-dsi: fix escape clock rate John Keeping
2017-02-24 12:54 ` [PATCH v4 14/23] drm/rockchip: dw-mipi-dsi: ensure PHY is reset John Keeping
2017-02-24 12:54 ` [PATCH v4 15/23] drm/rockchip: dw-mipi-dsi: configure PHY before enabling John Keeping
2017-02-24 12:54 ` [PATCH v4 16/23] drm/rockchip: dw-mipi-dsi: properly configure PHY timing John Keeping
2017-02-24 12:55 ` [PATCH v4 17/23] drm/rockchip: dw-mipi-dsi: improve PLL configuration John Keeping
2017-02-24 12:55 ` [PATCH v4 18/23] drm/rockchip: dw-mipi-dsi: use specific poll helper John Keeping
2017-02-24 12:55 ` [PATCH v4 19/23] drm/rockchip: dw-mipi-dsi: use positive check for N{H,V}SYNC John Keeping
2017-02-24 12:55 ` [PATCH v4 20/23] drm/rockchip: vop: test for P{H,V}SYNC John Keeping
2017-02-24 12:55 ` [PATCH v4 21/23] drm/rockchip: dw-mipi-dsi: defer probe if panel is not loaded John Keeping
2017-02-24 12:55 ` [PATCH v4 22/23] drm/rockchip: dw-mipi-dsi: support non-burst modes John Keeping
2017-02-24 12:55 ` [PATCH v4 23/23] drm/rockchip: dw-mipi-dsi: add reset control John Keeping
2017-03-02 21:56   ` Brian Norris
2017-03-03 11:39     ` [PATCH] dt-bindings: display: rk3288-mipi-dsi: add reset property John Keeping
2017-03-03 20:41       ` Brian Norris
2017-03-06 16:52       ` Sean Paul
2017-03-12 12:06       ` Rob Herring
2017-04-04 13:15         ` John Keeping
2017-04-04 18:30           ` Sean Paul
2017-03-02 21:59   ` [PATCH v4 23/23] drm/rockchip: dw-mipi-dsi: add reset control Brian Norris
2017-02-27  1:41 ` [PATCH v4 00/23] drm/rockchip: MIPI fixes & improvements Mark yao
2017-02-27  3:34 ` Chris Zhong
2017-03-01 20:03 ` Sean Paul

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=20170224125506.21533-7-john@metanate.com \
    --to=john@metanate.com \
    --cc=dri-devel@lists.freedesktop.org \
    --cc=linux-arm-kernel@lists.infradead.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-rockchip@lists.infradead.org \
    --cc=mark.yao@rock-chips.com \
    --cc=seanpaul@chromium.org \
    --cc=zyw@rock-chips.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox

all inboxes | Powered by JetHome®