From: Corentin Labbe <clabbe.montjoie@gmail.com>
To: robh+dt@kernel.org, mark.rutland@arm.com,
maxime.ripard@free-electrons.com, wens@csie.org,
linux@armlinux.org.uk, catalin.marinas@arm.com,
will.deacon@arm.com, peppe.cavallaro@st.com,
alexandre.torgue@st.com, davem@davemloft.net
Cc: f.fainelli@gmail.com, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org, netdev@vger.kernel.org,
linux-arm-kernel@lists.infradead.org,
Corentin Labbe <clabbe.montjoie@gmail.com>
Subject: [PATCH v2 00/20] net-next: stmmac: add dwmac-sun8i ethernet driver
Date: Tue, 14 Mar 2017 15:18:36 +0100 [thread overview]
Message-ID: <20170314141856.24560-1-clabbe.montjoie@gmail.com> (raw)
Hello
This patch series add the driver for dwmac-sun8i which handle the Ethernet MAC
present on Allwinner H3/H5/A83T/A64 SoCs.
This driver is the continuation of the sun8i-emac driver.
During the development, it appeared that in fact the hardware was a modified
version of some dwmac.
So the driver is now written as a glue driver for stmmac.
It supports 10/100/1000 Mbit/s speed with half/full duplex.
It can use an internal PHY (MII 10/100) or an external PHY
via RGMII/RMII.
This patch series enable the driver only for the H3/A64/H5 SoC since A83T
doesn't have the necessary clocks present in mainline.
The driver have been tested on the following boards:
- H3 Orange PI PC, BananaPI-M2+
- A64 Pine64, BananaPi-M64
- A83T BananaPI-M3
The first two patchs are some mandatory changes for letting dwmac-sun8i be used.
The following three patchs add the driver and its documentation.
The remaining are DT patch enabling it.
Regards
Corentin Labbe
Changes since v1:
- added TX/RX delay units
- splitted syscon documentation in its own patch
- regulator is now disabled after clk_prepare_enable(gmac->tx_clk) error
- Fixed a memory leak on mac_device_info
- Use now generic pin config for all DT stuff
- CONFIG_DWMAC_SUN8I is now set to y in defconfigs
Corentin Labbe (17):
net-next: stmmac: export stmmac_set_mac_addr/stmmac_get_mac_addr
net-next: stmmac: add optional setup function
ARM: sun8i: dt: Add DT bindings documentation for Allwinner
dwmac-sun8i
ARM: sun8i: dt: Add DT bindings documentation for Allwinner syscon
net-next: stmmac: Add dwmac-sun8i
ARM: dts: sunxi-h3-h5: Add dt node for the syscon control module
ARM: dts: sunxi-h3-h5: add dwmac-sun8i ethernet driver
ARM: dts: sun8i: Enable dwmac-sun8i on the Orange Pi 2
ARM: dts: sun8i: Enable dwmac-sun8i on the Orange PI One
ARM: dts: sun8i: Enable dwmac-sun8i on the Orange Pi plus
ARM: dts: sun8i: orangepi-pc-plus: Set EMAC activity LEDs to active
high
ARM64: dts: sun50i-a64: Add dt node for the syscon control module
ARM64: dts: sun50i-a64: add dwmac-sun8i Ethernet driver
ARM: dts: sun50i-a64: enable dwmac-sun8i on pine64
ARM: dts: sun50i-a64: enable dwmac-sun8i on pine64 plus
ARM: dts: sun50i-a64: enable dwmac-sun8i on the BananaPi M64
ARM: sunxi: Enable dwmac-sun8i driver on multi_v7_defconfig
LABBE Corentin (3):
ARM: dts: sun8i: Enable dwmac-sun8i on the Banana Pi M2+
ARM: dts: sun8i: Enable dwmac-sun8i on the Orange PI PC
ARM: sunxi: Enable dwmac-sun8i driver on sunxi_defconfig
.../devicetree/bindings/misc/allwinner,syscon.txt | 19 +
.../devicetree/bindings/net/dwmac-sun8i.txt | 77 ++
arch/arm/boot/dts/sun8i-h3-bananapi-m2-plus.dts | 37 +
arch/arm/boot/dts/sun8i-h3-orangepi-2.dts | 8 +
arch/arm/boot/dts/sun8i-h3-orangepi-one.dts | 8 +
arch/arm/boot/dts/sun8i-h3-orangepi-pc-plus.dts | 5 +
arch/arm/boot/dts/sun8i-h3-orangepi-pc.dts | 8 +
arch/arm/boot/dts/sun8i-h3-orangepi-plus.dts | 35 +
arch/arm/boot/dts/sunxi-h3-h5.dtsi | 39 +
arch/arm/configs/multi_v7_defconfig | 1 +
arch/arm/configs/sunxi_defconfig | 1 +
.../boot/dts/allwinner/sun50i-a64-bananapi-m64.dts | 14 +
.../boot/dts/allwinner/sun50i-a64-pine64-plus.dts | 16 +-
.../arm64/boot/dts/allwinner/sun50i-a64-pine64.dts | 15 +
arch/arm64/boot/dts/allwinner/sun50i-a64.dtsi | 43 +
drivers/net/ethernet/stmicro/stmmac/Kconfig | 11 +
drivers/net/ethernet/stmicro/stmmac/Makefile | 1 +
drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c | 938 +++++++++++++++++++++
drivers/net/ethernet/stmicro/stmmac/dwmac_lib.c | 3 +-
drivers/net/ethernet/stmicro/stmmac/stmmac_main.c | 31 +-
.../net/ethernet/stmicro/stmmac/stmmac_platform.c | 9 +-
include/linux/stmmac.h | 4 +
22 files changed, 1317 insertions(+), 6 deletions(-)
create mode 100644 Documentation/devicetree/bindings/misc/allwinner,syscon.txt
create mode 100644 Documentation/devicetree/bindings/net/dwmac-sun8i.txt
create mode 100644 drivers/net/ethernet/stmicro/stmmac/dwmac-sun8i.c
--
2.10.2
next reply other threads:[~2017-03-14 14:27 UTC|newest]
Thread overview: 25+ messages / expand[flat|nested] mbox.gz Atom feed top
2017-03-14 14:18 Corentin Labbe [this message]
2017-03-14 14:18 ` [PATCH v2 01/20] net-next: stmmac: export stmmac_set_mac_addr/stmmac_get_mac_addr Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 02/20] net-next: stmmac: add optional setup function Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 03/20] ARM: sun8i: dt: Add DT bindings documentation for Allwinner dwmac-sun8i Corentin Labbe
2017-03-20 22:21 ` Rob Herring
2017-03-14 14:18 ` [PATCH v2 04/20] ARM: sun8i: dt: Add DT bindings documentation for Allwinner syscon Corentin Labbe
2017-03-21 1:08 ` Rob Herring
2017-03-14 14:18 ` [PATCH v2 05/20] net-next: stmmac: Add dwmac-sun8i Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 06/20] ARM: dts: sunxi-h3-h5: Add dt node for the syscon control module Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 07/20] ARM: dts: sunxi-h3-h5: add dwmac-sun8i ethernet driver Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 08/20] ARM: dts: sun8i: Enable dwmac-sun8i on the Banana Pi M2+ Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 09/20] ARM: dts: sun8i: Enable dwmac-sun8i on the Orange PI PC Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 10/20] ARM: dts: sun8i: Enable dwmac-sun8i on the Orange Pi 2 Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 11/20] ARM: dts: sun8i: Enable dwmac-sun8i on the Orange PI One Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 12/20] ARM: dts: sun8i: Enable dwmac-sun8i on the Orange Pi plus Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 13/20] ARM: dts: sun8i: orangepi-pc-plus: Set EMAC activity LEDs to active high Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 14/20] ARM64: dts: sun50i-a64: Add dt node for the syscon control module Corentin Labbe
2017-03-15 11:06 ` Sergei Shtylyov
2017-03-14 14:18 ` [PATCH v2 15/20] ARM64: dts: sun50i-a64: add dwmac-sun8i Ethernet driver Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 16/20] ARM: dts: sun50i-a64: enable dwmac-sun8i on pine64 Corentin Labbe
2017-03-14 18:20 ` Florian Fainelli
2017-03-14 14:18 ` [PATCH v2 17/20] ARM: dts: sun50i-a64: enable dwmac-sun8i on pine64 plus Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 18/20] ARM: dts: sun50i-a64: enable dwmac-sun8i on the BananaPi M64 Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 19/20] ARM: sunxi: Enable dwmac-sun8i driver on sunxi_defconfig Corentin Labbe
2017-03-14 14:18 ` [PATCH v2 20/20] ARM: sunxi: Enable dwmac-sun8i driver on multi_v7_defconfig Corentin Labbe
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20170314141856.24560-1-clabbe.montjoie@gmail.com \
--to=clabbe.montjoie@gmail.com \
--cc=alexandre.torgue@st.com \
--cc=catalin.marinas@arm.com \
--cc=davem@davemloft.net \
--cc=devicetree@vger.kernel.org \
--cc=f.fainelli@gmail.com \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux@armlinux.org.uk \
--cc=mark.rutland@arm.com \
--cc=maxime.ripard@free-electrons.com \
--cc=netdev@vger.kernel.org \
--cc=peppe.cavallaro@st.com \
--cc=robh+dt@kernel.org \
--cc=wens@csie.org \
--cc=will.deacon@arm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®