From: Paul Cercueil <paul@crapouillou.net>
To: David Woodhouse <dwmw2@infradead.org>,
Brian Norris <computersforpeace@gmail.com>,
Boris Brezillon <bbrezillon@kernel.org>,
Marek Vasut <marek.vasut@gmail.com>,
Richard Weinberger <richard@nod.at>,
Rob Herring <robh+dt@kernel.org>,
Mark Rutland <mark.rutland@arm.com>,
Miquel Raynal <miquel.raynal@bootlin.com>,
Harvey Hunt <harveyhuntnexus@gmail.com>
Cc: Mathieu Malaterre <malat@debian.org>,
linux-mtd@lists.infradead.org, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org,
Paul Cercueil <paul@crapouillou.net>
Subject: [PATCH v2 2/9] dt-bindings: mtd: ingenic: Add compatible strings for the JZ4740
Date: Sat, 2 Feb 2019 20:19:19 -0300 [thread overview]
Message-ID: <20190202231926.2444-3-paul@crapouillou.net> (raw)
In-Reply-To: <20190202231926.2444-1-paul@crapouillou.net>
Add compatible strings to probe the jz4780-nand and jz4780-bch drivers
from devicetree on the JZ4725B and JZ4740 SoCs from Ingenic.
Signed-off-by: Paul Cercueil <paul@crapouillou.net>
---
Changes:
v2: - Change 'ingenic,jz4725b-nand' compatible string to
'ingenic,jz4740-nand' to reflect driver change
- Add 'ingenic,jz4740-bch' compatible string
- Document 'ingenic,oob-layout' property
.../devicetree/bindings/mtd/ingenic,jz4780-nand.txt | 13 +++++++++++--
1 file changed, 11 insertions(+), 2 deletions(-)
diff --git a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
index 29ea5853ca91..294b56a2098a 100644
--- a/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
+++ b/Documentation/devicetree/bindings/mtd/ingenic,jz4780-nand.txt
@@ -6,7 +6,9 @@ memory-controllers/ingenic,jz4780-nemc.txt), and thus NAND device nodes must
be children of the NEMC node.
Required NAND controller device properties:
-- compatible: Should be set to "ingenic,jz4780-nand".
+- compatible: Should be one of:
+ * ingenic,jz4740-nand
+ * ingenic,jz4780-nand
- reg: For each bank with a NAND chip attached, should specify a bank number,
an offset of 0 and a size of 0x1000000 (i.e. the whole NEMC bank).
@@ -15,6 +17,10 @@ Optional NAND controller device properties:
property must contain a phandle for the BCH controller node. The required
properties for this node are described below. If this is not specified,
software BCH will be used instead.
+- ingenic,oob-layout: Specify the OOB layout to replace the default one.
+ Valid values are:
+ * ingenic,jz4725b
+ * qi,lb60
Optional children nodes:
- Individual NAND chips are children of the NAND controller node.
@@ -72,7 +78,10 @@ NAND devices. The following is a description of the device properties for a
BCH controller.
Required BCH properties:
-- compatible: Should be set to "ingenic,jz4780-bch".
+- compatible: Should be one of:
+ * ingenic,jz4740-bch
+ * ingenic,jz4725b-bch
+ * ingenic,jz4780-bch
- reg: Should specify the BCH controller registers location and length.
- clocks: Clock for the BCH controller.
--
2.20.1
next prev parent reply other threads:[~2019-02-02 23:20 UTC|newest]
Thread overview: 29+ messages / expand[flat|nested] mbox.gz Atom feed top
2019-02-02 23:19 [PATCH v2 0/9] Ingenic JZ4780 NAND patchset v2 Paul Cercueil
2019-02-02 23:19 ` [PATCH v2 1/9] mtd: rawnand: Move drivers for Ingenic SoCs to subfolder Paul Cercueil
2019-02-02 23:19 ` Paul Cercueil [this message]
2019-02-18 19:20 ` [PATCH v2 2/9] dt-bindings: mtd: ingenic: Add compatible strings for the JZ4740 Rob Herring
2019-02-02 23:19 ` [PATCH v2 3/9] mtd: rawnand: jz4780: Use SPDX license notifiers Paul Cercueil
2019-02-02 23:19 ` [PATCH v2 4/9] mtd: rawnand: jz4780: Add support for the JZ4740 Paul Cercueil
2019-02-03 7:31 ` Boris Brezillon
2019-02-03 13:56 ` Paul Cercueil
2019-02-03 14:08 ` Boris Brezillon
2019-02-03 14:10 ` Paul Cercueil
2019-02-03 14:24 ` Boris Brezillon
2019-02-02 23:19 ` [PATCH v2 5/9] mtd: rawnand: jz4780: Add ooblayout for the JZ4725B Paul Cercueil
2019-02-03 7:21 ` Boris Brezillon
2019-02-02 23:19 ` [PATCH v2 6/9] mtd: rawnand: jz4780: Add ooblayout for the Qi Ben Nanonote Paul Cercueil
2019-02-03 7:30 ` Boris Brezillon
2019-02-02 23:19 ` [PATCH v2 7/9] mtd: rawnand: jz4780-bch: Separate top-level and SoC specific code Paul Cercueil
2019-02-02 23:19 ` [PATCH v2 8/9] mtd: rawnand: jz4780-bch: Add support for the JZ4725B Paul Cercueil
2019-02-02 23:19 ` [PATCH v2 9/9] mtd: rawnand: jz4780-bch: Add support for the JZ4740 Paul Cercueil
2019-02-03 7:35 ` Boris Brezillon
2019-02-03 13:58 ` Paul Cercueil
2019-02-03 14:16 ` Boris Brezillon
2019-02-03 14:56 ` Paul Cercueil
2019-02-03 15:07 ` Boris Brezillon
2019-02-03 15:41 ` Paul Cercueil
2019-02-04 9:26 ` kbuild test robot
2019-02-04 10:02 ` kbuild test robot
2019-02-03 7:20 ` [PATCH v2 0/9] Ingenic JZ4780 NAND patchset v2 Boris Brezillon
2019-02-03 13:01 ` Paul Cercueil
2019-02-03 14:04 ` Boris Brezillon
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=20190202231926.2444-3-paul@crapouillou.net \
--to=paul@crapouillou.net \
--cc=bbrezillon@kernel.org \
--cc=computersforpeace@gmail.com \
--cc=devicetree@vger.kernel.org \
--cc=dwmw2@infradead.org \
--cc=harveyhuntnexus@gmail.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-mtd@lists.infradead.org \
--cc=malat@debian.org \
--cc=marek.vasut@gmail.com \
--cc=mark.rutland@arm.com \
--cc=miquel.raynal@bootlin.com \
--cc=richard@nod.at \
--cc=robh+dt@kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®