[PATCH v3 0/4] RISC-V Hibernation Support

[Sia Jee Heng <jeeheng.sia@starfivetech.com>]

This series adds RISC-V Hibernation/suspend to disk support.
Low level Arch functions were created to support hibernation.
swsusp_arch_suspend() relies code from __cpu_suspend_enter() to write
cpu state onto the stack, then calling swsusp_save() to save the memory
image.

Arch specific hibernation header is implemented and is utilized by the
arch_hibernation_header_restore() and arch_hibernation_header_save()
functions. The arch specific hibernation header consists of satp, hartid,
and the cpu_resume address. The kernel built version is also need to be
saved into the hibernation image header to making sure only the same
kernel is restore when resume.

swsusp_arch_resume() creates a temporary page table that covering only
the linear map. It copies the restore code to a 'safe' page, then start to
restore the memory image. Once completed, it restores the original
kernel's page table. It then calls into __hibernate_cpu_resume()
to restore the CPU context. Finally, it follows the normal hibernation
path back to the hibernation core.

To enable hibernation/suspend to disk into RISCV, the below config
need to be enabled:
- CONFIG_ARCH_HIBERNATION_HEADER
- CONFIG_ARCH_HIBERNATION_POSSIBLE

At high-level, this series includes the following changes:
1) Change suspend_save_csrs() and suspend_restore_csrs()
   to public function as these functions are common to
   suspend/hibernation. (patch 1)
2) Refactor the common code in the __cpu_resume_enter() function and
   __hibernate_cpu_resume() function. The common code are used by
   hibernation and suspend. (patch 2)
3) Enhance kernel_page_present() function to support huge page. (patch 3)
4) Add arch/riscv low level functions to support
   hibernation/suspend to disk. (patch 4)

The above patches are based on kernel v6.2-rc5 and are tested on
StarFive VF2 SBC board and Qemu. 
ACPI platform mode is not supported in this series.

Changes since v2:
- Rebased to kernel v6.2-rc5
- Refactor the common code used by hibernation and suspend
- Create copy_page macro
- Solved other comments from Andrew and Conor

Changes since v1:
- Rebased to kernel v6.2-rc3
- Fixed bot's compilation error

Sia Jee Heng (4):
  RISC-V: Change suspend_save_csrs and suspend_restore_csrs to public
    function
  RISC-V: Factor out common code of __cpu_resume_enter()
  RISC-V: mm: Enable huge page support to kernel_page_present() function
  RISC-V: Add arch functions to support hibernation/suspend-to-disk

 arch/riscv/Kconfig                 |   7 +
 arch/riscv/include/asm/assembler.h |  82 +++++++
 arch/riscv/include/asm/suspend.h   |  24 ++
 arch/riscv/kernel/Makefile         |   1 +
 arch/riscv/kernel/asm-offsets.c    |   5 +
 arch/riscv/kernel/hibernate-asm.S  |  89 +++++++
 arch/riscv/kernel/hibernate.c      | 360 +++++++++++++++++++++++++++++
 arch/riscv/kernel/suspend.c        |   4 +-
 arch/riscv/kernel/suspend_entry.S  |  34 +--
 arch/riscv/mm/pageattr.c           |   6 +
 10 files changed, 579 insertions(+), 33 deletions(-)
 create mode 100644 arch/riscv/include/asm/assembler.h
 create mode 100644 arch/riscv/kernel/hibernate-asm.S
 create mode 100644 arch/riscv/kernel/hibernate.c


base-commit: 7c46948a6e9cf47ed03b0d489fde894ad46f1437
-- 
2.34.1