[PATCH] net: phy: phy_device: Fix PHY LED blinking code comment

[Marek Vasut <marex@denx.de>]

Fix copy-paste error in the code comment. The code refers to
LED blinking configuration, not brightness configuration. It
was likely copied from comment above this one which does
refer to brightness configuration.

Fixes: 4e901018432e ("net: phy: phy_device: Call into the PHY driver to set LED blinking")
Signed-off-by: Marek Vasut <marex@denx.de>
---
Cc: Andrew Lunn <andrew@lunn.ch>
Cc: Heiner Kallweit <hkallweit1@gmail.com>
Cc: Russell King <linux@armlinux.org.uk>
Cc: kernel@dh-electronics.com
Cc: linux-kernel@vger.kernel.org
Cc: netdev@vger.kernel.org
---
 include/linux/phy.h | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/include/linux/phy.h b/include/linux/phy.h
index 205fccfc0f60a..bd68f9d8e74f1 100644
--- a/include/linux/phy.h
+++ b/include/linux/phy.h
@@ -1119,21 +1119,21 @@ struct phy_driver {
 	/**
 	 * @led_brightness_set: Set a PHY LED brightness. Index
 	 * indicates which of the PHYs led should be set. Value
 	 * follows the standard LED class meaning, e.g. LED_OFF,
 	 * LED_HALF, LED_FULL.
 	 */
 	int (*led_brightness_set)(struct phy_device *dev,
 				  u8 index, enum led_brightness value);
 
 	/**
-	 * @led_blink_set: Set a PHY LED brightness.  Index indicates
+	 * @led_blink_set: Set a PHY LED blinking.  Index indicates
 	 * which of the PHYs led should be configured to blink. Delays
 	 * are in milliseconds and if both are zero then a sensible
 	 * default should be chosen.  The call should adjust the
 	 * timings in that case and if it can't match the values
 	 * specified exactly.
 	 */
 	int (*led_blink_set)(struct phy_device *dev, u8 index,
 			     unsigned long *delay_on,
 			     unsigned long *delay_off);
 	/**
-- 
2.43.0