Re: [PATCH v2 1/3] dt-bindings: Add Device Tree binding for ST M24LR control interface

[Abd-Alrhman Masalkhi <abd.masalkhi@gmail.com>]

Hi Krzysztof,

>> Is it acceptable to keep the current driver logic as-is, while limiting
>> the change to just fixing the binding and device tree representation?
>
> Dunno, did not look at your driver. Again, I am here talking about
> bindings. How you implement it in the driver is up to you. You have
> however one device with two addresses, so you should most likely have
> only one device node in DTS with two addresses. In certain cases, like
> separate resources and re-usability, children are common, but that was
> not really the case here.
>
> Look at ti,pcm6240.yaml, ti,tas2781.yaml and few others (you can git
> grep for them for reg with coma).

Okay, I'll rework the pathcs to use a single device node with two
addresses instead of modeling it as an I2C mux. Thanks also for the
hint about ti,pcm6240.yaml and ti,tas2781.yaml, I'll review those
to make sure the structure aligns properly.

I appreciate your guidance.

Best regards,
Abd-Alrhman Masalkhi