[PATCH V1 2/3] arm64: dts: qcom: sm8750: Add SDC2 nodes for sm8750 soc

[Sarthak Garg <sarthak.garg@oss.qualcomm.com>]

Add SD Card host controller for sm8750 soc.

Signed-off-by: Sarthak Garg <sarthak.garg@oss.qualcomm.com>
---
 arch/arm64/boot/dts/qcom/sm8750.dtsi | 63 ++++++++++++++++++++++++++++
 1 file changed, 63 insertions(+)

diff --git a/arch/arm64/boot/dts/qcom/sm8750.dtsi b/arch/arm64/boot/dts/qcom/sm8750.dtsi
index a82d9867c7cb..dce70443f719 100644
--- a/arch/arm64/boot/dts/qcom/sm8750.dtsi
+++ b/arch/arm64/boot/dts/qcom/sm8750.dtsi
@@ -2060,6 +2060,55 @@ ice: crypto@1d88000 {
 			clocks = <&gcc GCC_UFS_PHY_ICE_CORE_CLK>;
 		};
 
+		sdhc_2: mmc@8804000 {
+			compatible = "qcom,sm8750-sdhci", "qcom,sdhci-msm-v5";
+			reg = <0 0x08804000 0 0x1000>;
+
+			interrupts = <GIC_SPI 207 IRQ_TYPE_LEVEL_HIGH>,
+					<GIC_SPI 223 IRQ_TYPE_LEVEL_HIGH>;
+			interrupt-names = "hc_irq", "pwr_irq";
+
+			clocks = <&gcc GCC_SDCC2_AHB_CLK>,
+				<&gcc GCC_SDCC2_APPS_CLK>,
+				<&rpmhcc RPMH_CXO_CLK>;
+			clock-names = "iface", "core", "xo";
+
+			interconnects = <&aggre2_noc MASTER_SDCC_2 QCOM_ICC_TAG_ALWAYS
+					&mc_virt SLAVE_EBI1 QCOM_ICC_TAG_ALWAYS>,
+					<&gem_noc MASTER_APPSS_PROC QCOM_ICC_TAG_ACTIVE_ONLY
+					&config_noc SLAVE_SDCC_2 QCOM_ICC_TAG_ACTIVE_ONLY>;
+			interconnect-names = "sdhc-ddr", "cpu-sdhc";
+
+			power-domains = <&rpmhpd RPMHPD_CX>;
+			operating-points-v2 = <&sdhc2_opp_table>;
+
+			qcom,dll-config = <0x0007442c>;
+			qcom,ddr-config = <0x80040868>;
+
+			iommus = <&apps_smmu 0x540 0x0>;
+			dma-coherent;
+
+			bus-width = <4>;
+			max-sd-hs-hz = <37500000>;
+
+			resets = <&gcc GCC_SDCC2_BCR>;
+			status = "disabled";
+
+			sdhc2_opp_table: opp-table {
+				compatible = "operating-points-v2";
+
+				opp-100000000 {
+					opp-hz = /bits/ 64 <100000000>;
+					required-opps = <&rpmhpd_opp_low_svs>;
+				};
+
+				opp-202000000 {
+					opp-hz = /bits/ 64 <202000000>;
+					required-opps = <&rpmhpd_opp_nom>;
+				};
+			};
+		};
+
 		cryptobam: dma-controller@1dc4000 {
 			compatible = "qcom,bam-v1.7.4", "qcom,bam-v1.7.0";
 			reg = <0x0 0x01dc4000 0x0 0x28000>;
@@ -3121,6 +3170,13 @@ data-pins {
 					drive-strength = <2>;
 					bias-pull-up;
 				};
+
+				card-detect-pins {
+					pins = "gpio55";
+					function = "gpio";
+					drive-strength = <2>;
+					bias-pull-up;
+				};
 			};
 
 			sdc2_default: sdc2-default-state {
@@ -3141,6 +3197,13 @@ data-pins {
 					drive-strength = <10>;
 					bias-pull-up;
 				};
+
+				card-detect-pins {
+					pins = "gpio55";
+					function = "gpio";
+					drive-strength = <2>;
+					bias-pull-up;
+				};
 			};
 		};
 
-- 
2.34.1