[PATCH v3] media: qcom: iris: guard IRQ handler with runtime PM check

[Hungyu Lin <dennylin0707@gmail.com>]

Use pm_runtime_get_if_active() before accessing hardware
registers in the threaded IRQ handler. Skip interrupt processing
when the device is not active.

Signed-off-by: Hungyu Lin <dennylin0707@gmail.com>
---
v2:
- Use pm_runtime_get_if_active() instead of pm_runtime_get_if_in_use()
- Handle negative runtime PM return values correctly
- Return IRQ_NONE when interrupt processing is skipped

v3:
- Remove the early enable_irq() from the PM-inactive early-return path
- IRQ re-enablement is already handled by iris_vpu_power_on() after power-on

 drivers/media/platform/qcom/iris/iris_hfi_common.c | 7 +++++++
 1 file changed, 7 insertions(+)

diff --git a/drivers/media/platform/qcom/iris/iris_hfi_common.c b/drivers/media/platform/qcom/iris/iris_hfi_common.c
index 621c66593d88..59040cce8cf1 100644
--- a/drivers/media/platform/qcom/iris/iris_hfi_common.c
+++ b/drivers/media/platform/qcom/iris/iris_hfi_common.c
@@ -100,10 +100,15 @@ irqreturn_t iris_hfi_isr(int irq, void *data)
 irqreturn_t iris_hfi_isr_handler(int irq, void *data)
 {
 	struct iris_core *core = data;
+	int ret;
 
 	if (!core)
 		return IRQ_NONE;
 
+	ret = pm_runtime_get_if_active(core->dev);
+	if (ret <= 0)
+		return IRQ_NONE;
+
 	mutex_lock(&core->lock);
 	pm_runtime_mark_last_busy(core->dev);
 	iris_vpu_clear_interrupt(core);
@@ -111,6 +116,8 @@ irqreturn_t iris_hfi_isr_handler(int irq, void *data)
 
 	core->hfi_response_ops->hfi_response_handler(core);
 
+	pm_runtime_put_autosuspend(core->dev);
+
 	if (!iris_vpu_watchdog(core, core->intr_status))
 		enable_irq(irq);
 
-- 
2.34.1