[PATCH 0/3] ASoC: fix typos in comments

[PATCH 0/3] ASoC: fix typos in comments

[Hemanth Selam]

This corrects 3 misspellings in comments.  Each is a separate patch so
that any one of them can be dropped without touching the rest.

Nothing outside comments changes.  Every touched C file was checked by
dropping its comments, replacing each string literal with a placeholder
and collapsing whitespace; what remained was identical before and after,
so the compiled code cannot differ.

The mistakes were found with scripts/checkpatch.pl against the list in
scripts/spelling.txt.  The scanning, the edits and the changelogs were
produced with Cursor running the claude-opus-5 model, from a request to
find and fix spelling mistakes across the tree, and every correction was
then re-checked by the comparison described above.  Words that name an
identifier were left alone deliberately, even when they read as typos,
because correcting the prose would make the comment disagree with the
code it describes.

Tested by building x86_64 defconfig at v7.3-rc1-269-gbc35965f6940, which
is clean.  Nothing else was built, so any patch touching code that
x86_64 defconfig does not compile has been read but not compiled.

Hemanth Selam (3):
  ASoC: codecs: fix typos in comments
  firmware: cirrus: fix typo "upto" in comment
  mfd: fix typo "convertor" in comment

 drivers/firmware/cirrus/cs_dsp.c | 2 +-
 drivers/mfd/wm831x-auxadc.c      | 2 +-
 sound/soc/codecs/wm8962.c        | 4 ++--
 sound/soc/codecs/wm8996.c        | 2 +-
 sound/soc/codecs/wm_hubs.c       | 2 +-
 5 files changed, 6 insertions(+), 6 deletions(-)

-- 
2.48.1

[PATCH 1/3] ASoC: codecs: fix typos in comments

[Hemanth Selam]

Fix typos in comments, reported by scripts/checkpatch.pl using the
misspelling list in scripts/spelling.txt.  Only touches comments, no code
changes.

Assisted-by: Cursor:claude-opus-5
Signed-off-by: Hemanth Selam <hemanth.selam@gmail.com>
---
 sound/soc/codecs/wm8962.c  | 4 ++--
 sound/soc/codecs/wm8996.c  | 2 +-
 sound/soc/codecs/wm_hubs.c | 2 +-
 3 files changed, 4 insertions(+), 4 deletions(-)

diff --git a/sound/soc/codecs/wm8962.c b/sound/soc/codecs/wm8962.c
index 8a9598161b35..af4716051220 100644
--- a/sound/soc/codecs/wm8962.c
+++ b/sound/soc/codecs/wm8962.c
@@ -3430,7 +3430,7 @@ static int wm8962_gpio_request(struct gpio_chip *chip, unsigned offset)
 
 	/* The WM8962 GPIOs aren't linearly numbered.  For simplicity
 	 * we export linear numbers and error out if the unsupported
-	 * ones are requsted.
+	 * ones are requested.
 	 */
 	switch (offset + 1) {
 	case 2:
@@ -3813,7 +3813,7 @@ static int wm8962_i2c_probe(struct i2c_client *i2c)
 	regmap_update_bits(wm8962->regmap, WM8962_EQ1,
 			   WM8962_EQ_SHARED_COEFF, 0);
 
-	/* Don't debouce interrupts so we don't need SYSCLK */
+	/* Don't debounce interrupts so we don't need SYSCLK */
 	regmap_update_bits(wm8962->regmap, WM8962_IRQ_DEBOUNCE,
 			   WM8962_FLL_LOCK_DB | WM8962_PLL3_LOCK_DB |
 			   WM8962_PLL2_LOCK_DB | WM8962_TEMP_SHUT_DB,
diff --git a/sound/soc/codecs/wm8996.c b/sound/soc/codecs/wm8996.c
index dface555f928..e7a20ce39940 100644
--- a/sound/soc/codecs/wm8996.c
+++ b/sound/soc/codecs/wm8996.c
@@ -2106,7 +2106,7 @@ static int wm8996_set_fll(struct snd_soc_component *component, int fll_id, int s
 	if (i2c->irq)
 		timeout *= 10;
 	else
-		/* ensure timeout of atleast 1 jiffies */
+		/* ensure timeout of at least 1 jiffies */
 		timeout = (timeout/2) ? : 1;
 
 	for (retry = 0; retry < 10; retry++) {
diff --git a/sound/soc/codecs/wm_hubs.c b/sound/soc/codecs/wm_hubs.c
index f80dfc488e3c..019940589e51 100644
--- a/sound/soc/codecs/wm_hubs.c
+++ b/sound/soc/codecs/wm_hubs.c
@@ -338,7 +338,7 @@ static int wm8993_put_dc_servo(struct snd_kcontrol *kcontrol,
 	ret = snd_soc_put_volsw(kcontrol, ucontrol);
 
 	/* If we're applying an offset correction then updating the
-	 * callibration would be likely to introduce further offsets. */
+	 * calibration would be likely to introduce further offsets. */
 	if (hubs->dcs_codes_l || hubs->dcs_codes_r || hubs->no_series_update)
 		return ret;
 
-- 
2.48.1

[PATCH 2/3] firmware: cirrus: fix typo "upto" in comment

[Hemanth Selam]

Correct "upto" to "up to", reported by scripts/checkpatch.pl using the
misspelling list in scripts/spelling.txt.  Only touches comments, no code
changes.

Assisted-by: Cursor:claude-opus-5
Signed-off-by: Hemanth Selam <hemanth.selam@gmail.com>
---
 drivers/firmware/cirrus/cs_dsp.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/firmware/cirrus/cs_dsp.c b/drivers/firmware/cirrus/cs_dsp.c
index bb93b24c659d..04015280ac5d 100644
--- a/drivers/firmware/cirrus/cs_dsp.c
+++ b/drivers/firmware/cirrus/cs_dsp.c
@@ -3505,7 +3505,7 @@ EXPORT_SYMBOL_NS_GPL(cs_dsp_chunk_write, "FW_CS_DSP");
  *
  * As cs_dsp_chunk_write only writes data when a whole DSP word is ready to
  * be written out it is possible that some data will remain in the cache, this
- * function will pad that data with zeros upto a whole DSP word and write out.
+ * function will pad that data with zeros up to a whole DSP word and write out.
  *
  * Return: Zero for success, a negative number on error.
  */
-- 
2.48.1

[PATCH 3/3] mfd: fix typo "convertor" in comment

[Hemanth Selam]

Correct "convertor" to "converter", reported by scripts/checkpatch.pl using
the misspelling list in scripts/spelling.txt.  Only touches comments, no
code changes.

Assisted-by: Cursor:claude-opus-5
Signed-off-by: Hemanth Selam <hemanth.selam@gmail.com>
---
 drivers/mfd/wm831x-auxadc.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

diff --git a/drivers/mfd/wm831x-auxadc.c b/drivers/mfd/wm831x-auxadc.c
index 744e1d161c5a..6280d4f38981 100644
--- a/drivers/mfd/wm831x-auxadc.c
+++ b/drivers/mfd/wm831x-auxadc.c
@@ -132,7 +132,7 @@ static irqreturn_t wm831x_auxadc_irq(int irq, void *irq_data)
 			1 << input, 0);
 	wm831x->auxadc_active &= ~(1 << input);
 
-	/* Turn off the entire convertor if idle */
+	/* Turn off the entire converter if idle */
 	if (!wm831x->auxadc_active)
 		wm831x_reg_write(wm831x, WM831X_AUXADC_CONTROL, 0);
 
-- 
2.48.1