[PATCH] usb: dwc3: tell xHCI that it lost its state when the core is powered off

[PATCH] usb: dwc3: tell xHCI that it lost its state when the core is powered off

[Joonhoe Kim]

In host mode, dwc3_suspend_common() powers the core off for system
suspend (dwc3_core_exit()) when the controller may not wake the system
or needs a full re-init. The xHCI registers and the state saved with
the Controller Save State command are gone then, but nothing tells
xhci-plat: xhci_resume() takes the "state intact" path, writes the
saved registers back and asks the controller to restore its state
(CRS).

xhci-plat has a flag for exactly this, power_lost (commit 668cc6bc1178
("usb: host: xhci-plat: allow upper layers to signal power loss"), used
by cdns3), but dwc3 never sets it.

On a Lenovo TB323FU (SM8850, DWC3 + eUSB2 PHY) with a USB 2.0 hub, a
USB 3 flash drive and a Billboard device attached, and USB wakeup
disabled, s2idle then broke the host controller on resume: either the
controller wrote to an address that was not mapped

  arm-smmu 15000000.iommu: Unhandled context fault: fsr=0x402,
    iova=0xd85e7c300, fsynr=0x3d0011, cbfrsynra=0x40, cb=13
  xhci-hcd xhci-hcd.2.auto: WARNING: Host System Error
  usb 1-1: hub failed to enable device, error -108

or its command ring would not stop

  xhci-hcd xhci-hcd.2.auto: Abort failed to stop command ring: -110
  xhci-hcd xhci-hcd.2.auto: xHCI host controller not responding, assume dead
  xhci-hcd xhci-hcd.2.auto: HC died; cleaning up
  usb 1-1: PM: **** DPM device timeout ****
  Kernel panic - not syncing: usb 1-1: unrecoverable failure

With wakeup enabled (the core stays powered) the same setup survived
every cycle.

Remember that the core was powered off and hand it to xhci-plat as
power_lost from a resume_quirk, so that xhci_resume() resets the
controller and the devices are re-enumerated. Unlike a static
XHCI_RESET_ON_RESUME this only applies to the resumes that follow a
power-off; resumes with the core kept powered (wakeup enabled) and
runtime resume keep the restore path.

Same kernel and setup, 30 s RTC s2idle, wakeup disabled: without this
change 1/1 cycles lost the controller, with it 3/3 cycles kept all
devices. Only tested on this device.

Fixes: c4a5153e87fd ("usb: dwc3: core: Power-off core/PHYs on system_suspend in host mode")
Assisted-by: LLM
Signed-off-by: Joonhoe Kim <26rote@gmail.com>
---
host.c now includes ../host/xhci.h (for hcd_to_xhci_priv()) in place
of the three xHCI headers it used, as cdns3's host.c does.

 drivers/usb/dwc3/core.c |  2 ++
 drivers/usb/dwc3/core.h |  3 +++
 drivers/usb/dwc3/host.c | 20 +++++++++++++++++---
 3 files changed, 22 insertions(+), 3 deletions(-)

diff --git a/drivers/usb/dwc3/core.c b/drivers/usb/dwc3/core.c
index fd5c2cd36c59..b5490b9a8474 100644
--- a/drivers/usb/dwc3/core.c
+++ b/drivers/usb/dwc3/core.c
@@ -2572,8 +2572,10 @@ static int dwc3_suspend_common(struct dwc3 *dwc, pm_message_t msg)
 		if (!PMSG_IS_AUTO(msg) &&
 		    (!device_may_wakeup(dwc->dev) || dwc->needs_full_reinit)) {
 			dwc3_core_exit(dwc);
+			dwc->xhci_power_lost = 1;
 			break;
 		}
+		dwc->xhci_power_lost = 0;
 
 		/* Let controller to suspend HSPHY before PHY driver suspends */
 		if (dwc->dis_u2_susphy_quirk ||
diff --git a/drivers/usb/dwc3/core.h b/drivers/usb/dwc3/core.h
index 608daeb7ef10..1aa898b343e6 100644
--- a/drivers/usb/dwc3/core.h
+++ b/drivers/usb/dwc3/core.h
@@ -1172,6 +1172,8 @@ struct dwc3_glue_ops {
  * @suspended: set to track suspend event due to U3/L2.
  * @susphy_state: state of DWC3_GUSB2PHYCFG_SUSPHY + DWC3_GUSB3PIPECTL_SUSPHY
  *		  before PM suspend.
+ * @xhci_power_lost: the core was powered off for system suspend in host
+ *		     mode; xHCI must not try to restore its state on resume
  * @imod_interval: set the interrupt moderation interval in 250ns
  *			increments or 0 to disable.
  * @max_cfg_eps: current max number of IN eps used across all USB configs.
@@ -1420,6 +1422,7 @@ struct dwc3 {
 	unsigned		wakeup_configured:1;
 	unsigned		suspended:1;
 	unsigned		susphy_state:1;
+	unsigned		xhci_power_lost:1;
 
 	u16			imod_interval;
 
diff --git a/drivers/usb/dwc3/host.c b/drivers/usb/dwc3/host.c
index c5674161b2b0..c7143a8e3e32 100644
--- a/drivers/usb/dwc3/host.c
+++ b/drivers/usb/dwc3/host.c
@@ -14,9 +14,7 @@
 #include <linux/usb/hcd.h>
 #include <linux/bitfield.h>
 
-#include "../host/xhci-port.h"
-#include "../host/xhci-ext-caps.h"
-#include "../host/xhci-caps.h"
+#include "../host/xhci.h"
 #include "../host/xhci-plat.h"
 #include "core.h"
 
@@ -78,7 +76,23 @@ static void dwc3_xhci_plat_start(struct usb_hcd *hcd)
 	dwc3_enable_susphy(dwc, true);
 }
 
+/*
+ * dwc3_suspend_common() powers the core off for system suspend in host mode
+ * when the controller may not wake the system. The xHCI registers and its
+ * saved internal state are gone then: tell xhci-plat, so that xhci_resume()
+ * resets the controller instead of restoring registers and asking it to
+ * restore a state it no longer has.
+ */
+static int dwc3_xhci_resume_quirk(struct usb_hcd *hcd)
+{
+	struct dwc3 *dwc = dev_get_drvdata(hcd->self.controller->parent);
+
+	hcd_to_xhci_priv(hcd)->power_lost = dwc->xhci_power_lost;
+	return 0;
+}
+
 static const struct xhci_plat_priv dwc3_xhci_plat_quirk = {
+	.resume_quirk = dwc3_xhci_resume_quirk,
 	.plat_start = dwc3_xhci_plat_start,
 };
 

base-commit: 6375e61c01e93e35ee7acd336a689ac1fae4b509
-- 
2.43.0