[PATCH v2 03/13] media: sony-starvis2: Always program the sensor in window mode

[Dave Stevenson <dave.stevenson@raspberrypi.com>]

If the requested region matched the defined active area then
the driver switched to all-pixel mode. This left the possibility
that the active area was incorrect and not reading out the area
expected.

Switch to always requesting window mode to avoid this potential
mismatch.

Signed-off-by: Dave Stevenson <dave.stevenson@raspberrypi.com>
---
 drivers/media/i2c/sony-starvis2.c | 4 +---
 1 file changed, 1 insertion(+), 3 deletions(-)

diff --git a/drivers/media/i2c/sony-starvis2.c b/drivers/media/i2c/sony-starvis2.c
index c7fbc5c132f4..20f3489b58d3 100644
--- a/drivers/media/i2c/sony-starvis2.c
+++ b/drivers/media/i2c/sony-starvis2.c
@@ -918,9 +918,7 @@ static int starvis2_program_window(struct starvis2 *starvis2,
 	int ret = 0;
 
 	cci_write(starvis2->cci, STARVIS2_REG_ADDMODE, 0x00, &ret);
-	cci_write(starvis2->cci, STARVIS2_REG_WINMODE,
-		  v4l2_rect_equal(crop, &imx678_active_area) ? 0x00 : 0x04,
-		  &ret);
+	cci_write(starvis2->cci, STARVIS2_REG_WINMODE, 0x04, &ret);
 	cci_write(starvis2->cci, STARVIS2_REG_PIX_HST,
 		  crop->left - imx678_active_area.left, &ret);
 	cci_write(starvis2->cci, STARVIS2_REG_PIX_HWIDTH, crop->width, &ret);

-- 
2.34.1