Re: [PATCH 4/4] pinctrl: amd: Use amd_pinconf_set() for all config options

[Mario Limonciello <mario.limonciello@amd.com>]

On 7/3/23 16:35, andy.shevchenko@gmail.com wrote:
> Fri, Jun 30, 2023 at 02:47:16PM -0500, Mario Limonciello kirjoitti:
>> On ASUS TUF A16 it is reported that the ITE5570 ACPI device connected to
>> GPIO 7 is causing an interrupt storm.  This issue doesn't happen on
>> Windows.
>>
>> Comparing the GPIO register configuration between Windows and Linux
>> bit 20 has been configured as a pull up on Windows, but not on Linux.
>> Checking GPIO declaration from the firmware it is clear it *should* have
>> been a pull up on Linux as well.
>>
>> ```
>>                      GpioInt (Level, ActiveLow, Exclusive, PullUp, 0x0000,
>>                          "\\_SB.GPIO", 0x00, ResourceConsumer, ,
>>                          )
>>                          {   // Pin list
>>                              0x0007
>>                          }
> 
> I beleive we do not need so many heading spaces in the above
> 

OK, will fix it up.

>> ```
>>
>> On Linux amd_gpio_set_config() is currently only used for programming
>> the debounce. Actually the GPIO core calls it with all the arguments
>> that are supported by a GPIO, pinctrl-amd just responds `-ENOTSUPP`.
>>
>> To solve this issue expand amd_gpio_set_config() to support the other
>> arguments amd_pinconf_set() supports, namely `PIN_CONFIG_BIAS_PULL_DOWN`,
>> `PIN_CONFIG_BIAS_PULL_UP`, and `PIN_CONFIG_DRIVE_STRENGTH`.
> 
> ...
> 
>> Fixes: 2956b5d94a76b ("pinctrl / gpio: Introduce .set_config() callback for GPIO chips")
> 
> Can you group fixes at the beginning of the series?
> 

I'm a bit wary of this because the other commits fix it so that debounce 
handling works properly before this is wired up.  If I put this patch 
earlier I'll need to make sure it's only used for the new options and 
not debounce.

But I'll think about how to do it.