Re: [PATCH 3/3] arm64: dts: rockchip: Add vdd_cpu_big regulators to rk3588-rock-5b

[Cristian Ciocaltea <cristian.ciocaltea@collabora.com>]

On 4/14/23 14:29, Krzysztof Kozlowski wrote:
> On 14/04/2023 12:40, Cristian Ciocaltea wrote:
>> On 4/14/23 13:27, Krzysztof Kozlowski wrote:
>>> On 14/04/2023 11:34, Cristian Ciocaltea wrote:
>>>> The RK8602 and RK8603 voltage regulators on the Rock 5B board provide
>>>> the power lines vdd_cpu_big0 and vdd_cpu_big1, respectively.
>>>>
>>>> Add the necessary device tree nodes and bind them to the corresponding
>>>> CPU big core nodes.
>>>>
>>>> Signed-off-by: Cristian Ciocaltea <cristian.ciocaltea@collabora.com>
>>>> ---
>>>>  .../boot/dts/rockchip/rk3588-rock-5b.dts      | 56 +++++++++++++++++++
>>>>  1 file changed, 56 insertions(+)
>>>>
>>>> diff --git a/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts b/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
>>>> index 8cc97d146a73..3e4aee8f70c1 100644
>>>> --- a/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
>>>> +++ b/arch/arm64/boot/dts/rockchip/rk3588-rock-5b.dts
>>>> @@ -53,6 +53,62 @@ vcc5v0_sys: vcc5v0-sys-regulator {
>>>>  	};
>>>>  };
>>>>  
>>>> +&cpu_b0 {
>>>> +	cpu-supply = <&vdd_cpu_big0_s0>;
>>>> +};
>>>> +
>>>> +&cpu_b1 {
>>>> +	cpu-supply = <&vdd_cpu_big0_s0>;
>>>> +};
>>>> +
>>>> +&cpu_b2 {
>>>> +	cpu-supply = <&vdd_cpu_big1_s0>;
>>>> +};
>>>> +
>>>> +&cpu_b3 {
>>>> +	cpu-supply = <&vdd_cpu_big1_s0>;
>>>> +};
>>>> +
>>>> +&i2c0 {
>>>> +	pinctrl-names = "default";
>>>> +	pinctrl-0 = <&i2c0m2_xfer>;
>>>> +	status = "okay";
>>>> +
>>>> +	vdd_cpu_big0_s0: regulator@42 {
>>>> +		compatible = "rockchip,rk8602";
>>>
>>> Looking at your next node, this is surprising... Double check if you
>>> have correct compatibles everywhere.
>>>
>>>> +		reg = <0x42>;
>>>> +		fcs,suspend-voltage-selector = <1>;
>>>
>>> Does not look like you tested the DTS against bindings. Please run `make
>>> dtbs_check` (see Documentation/devicetree/bindings/writing-schema.rst
>>> for instructions).
>>>
>>>> +		regulator-name = "vdd_cpu_big0_s0";
>>>> +		regulator-always-on;
>>>> +		regulator-boot-on;
>>>> +		regulator-min-microvolt = <550000>;
>>>> +		regulator-max-microvolt = <1050000>;
>>>> +		regulator-ramp-delay = <2300>;
>>>> +		vin-supply = <&vcc5v0_sys>;
>>>> +
>>>> +		regulator-state-mem {
>>>> +			regulator-off-in-suspend;
>>>> +		};
>>>> +	};
>>>> +
>>>> +	vdd_cpu_big1_s0: regulator@43 {
>>>> +		compatible = "rockchip,rk8603", "rockchip,rk8602";
>>>> +		reg = <0x43>;
>>>> +		fcs,suspend-voltage-selector = <1>;
>>>
>>> Does not look like you tested the DTS against bindings. Please run `make
>>> dtbs_check` (see Documentation/devicetree/bindings/writing-schema.rst
>>> for instructions).
>>
>> I mentioned in the cover letter that the support for the RK860X 
>> regulators has been recently merged via [1]. The patches in this 
>> series have been verified on next-20230413.
> 
> OK. The question about compatibles still stays - but maybe you have
> indeed 8603 and 8602 in the same time.

Yes, according to [1], initially discussed in [2].

[1] https://lore.kernel.org/lkml/20230406194158.963352-2-cristian.ciocaltea@collabora.com/
[2] https://lore.kernel.org/lkml/ea1dfe0f-4ed3-9bfb-dc6b-6d87b0267a99@linaro.org/

Regards,
Cristian