mirror of https://lore.kernel.org/lkml/
 help / color / mirror / Atom feed
From: Shawn Lin <shawn.lin@rock-chips.com>
To: Douglas Anderson <dianders@chromium.org>,
	ulf.hansson@linaro.org, kishon@ti.com,
	Heiko Stuebner <heiko@sntech.de>,
	robh+dt@kernel.org
Cc: shawn.lin@rock-chips.com, xzy.xu@rock-chips.com,
	briannorris@chromium.org, adrian.hunter@intel.com,
	linux-rockchip@lists.infradead.org, linux-mmc@vger.kernel.org,
	devicetree@vger.kernel.org, pawel.moll@arm.com,
	mark.rutland@arm.com, ijc+devicetree@hellion.org.uk,
	galak@codeaurora.org, linux-kernel@vger.kernel.org
Subject: Re: [PATCH v2 03/11] Documentation: mmc: sdhci-of-arasan: Add soc-ctl-syscon for corecfg regs
Date: Tue, 14 Jun 2016 08:33:54 +0800	[thread overview]
Message-ID: <39b13297-782e-043f-96d3-95643f188f31@rock-chips.com> (raw)
In-Reply-To: <1465859076-4868-4-git-send-email-dianders@chromium.org>

在 2016/6/14 7:04, Douglas Anderson 写道:
> As can be seen in Arasan's datasheet [1] there are several "corecfg"
> settings in their SDHCI IP Block that are supposed to be controlled by
> software.  Although the datasheet referenced is a bit vague about how to
> access corecfg, in Figure 5 you can see that for Arasan's PHY (a
> separate component than their SDHCI component) they describe the
> "phyctrl" registers as being "FROM SOC CTL REG", implying that it's up
> to the licensee of the Arasan IP block to implement these registers.  It
> seems sane to assume that the "corecfg" registers in their SDHCI IP
> block works in a similar way for all licensees of the IP Block.
>
> Device tree has a model that allows a device to get a reference to
> random registers located elsewhere in the SoC: sysctl.  Let's leverage
> this model and allow adding a sysctl reference to access the control
> registers for the Arasan SDHCI PHYs.
>
> Having a reference to the control registers doesn't do much for us on
> its own since the Arasan spec doesn't specify how these corecfg values
> are laid out in memory.  In the SDHCI driver we'll need a map detailing
> where each corecfg can be found in each implementation.  This map can be
> found using the primary compatible string of the SDHCI device.  In that
> spirit, document that existing rk3399 device trees already have a
> specific compatible string, though up to now they've always been relying
> on the driver supporting the generic.
>
> Note that since existing devices seem to work fairly well as-is, we'll
> list the syscon reference as "optional", but it's likely that we'll run
> into much fewer problems if we can actually set the proper values in the
> syscon, so it is strongly suggested that any SoCs where we have a map to
> set the corecfg also include a reference to the syscon.
>
> [1]: https://arasan.com/wp-content/media/eMMC-5-1-Total-Solution_Rev-1-3.pdf


Looks good.

Reviewed-by: Shawn Lin <shawn.lin@rock-chips.com>

>
> Signed-off-by: Douglas Anderson <dianders@chromium.org>
> Acked-by: Rob Herring <robh@kernel.org>
> ---
> Changes in v2:
> - Clean up description of rk3399 PHY (Shawn)
> - Add Rob Herring's Ack.
>
>  .../devicetree/bindings/mmc/arasan,sdhci.txt       | 27 ++++++++++++++++++++--
>  1 file changed, 25 insertions(+), 2 deletions(-)
>
> diff --git a/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt b/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt
> index 31b35c3a5e47..476604e6ce2a 100644
> --- a/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt
> +++ b/Documentation/devicetree/bindings/mmc/arasan,sdhci.txt
> @@ -9,8 +9,12 @@ Device Tree Bindings for the Arasan SDHCI Controller
>    [4] Documentation/devicetree/bindings/phy/phy-bindings.txt
>
>  Required Properties:
> -  - compatible: Compatibility string. Must be 'arasan,sdhci-8.9a' or
> -                'arasan,sdhci-4.9a' or 'arasan,sdhci-5.1'
> +  - compatible: Compatibility string.  One of:
> +    - "arasan,sdhci-8.9a": generic Arasan SDHCI 8.9a PHY
> +    - "arasan,sdhci-4.9a": generic Arasan SDHCI 4.9a PHY
> +    - "arasan,sdhci-5.1": generic Arasan SDHCI 5.1 PHY
> +    - "rockchip,rk3399-sdhci-5.1", "arasan,sdhci-5.1": rk3399 eMMC PHY
> +      For this device it is strongly suggested to include arasan,soc-ctl-syscon.
>    - reg: From mmc bindings: Register location and length.
>    - clocks: From clock bindings: Handles to clock inputs.
>    - clock-names: From clock bindings: Tuple including "clk_xin" and "clk_ahb"
> @@ -22,6 +26,11 @@ Required Properties for "arasan,sdhci-5.1":
>    - phys: From PHY bindings: Phandle for the Generic PHY for arasan.
>    - phy-names:  MUST be "phy_arasan".
>
> +Optional Properties:
> +  - arasan,soc-ctl-syscon: A phandle to a syscon device (see ../mfd/syscon.txt)
> +    used to access core corecfg registers.  Offsets of registers in this
> +    syscon are determined based on the main compatible string for the device.
> +
>  Example:
>  	sdhci@e0100000 {
>  		compatible = "arasan,sdhci-8.9a";
> @@ -42,3 +51,17 @@ Example:
>  		phys = <&emmc_phy>;
>  		phy-names = "phy_arasan";
>  	} ;
> +
> +	sdhci: sdhci@fe330000 {
> +		compatible = "rockchip,rk3399-sdhci-5.1", "arasan,sdhci-5.1";
> +		reg = <0x0 0xfe330000 0x0 0x10000>;
> +		interrupts = <GIC_SPI 11 IRQ_TYPE_LEVEL_HIGH>;
> +		clocks = <&cru SCLK_EMMC>, <&cru ACLK_EMMC>;
> +		clock-names = "clk_xin", "clk_ahb";
> +		arasan,soc-ctl-syscon = <&grf>;
> +		assigned-clocks = <&cru SCLK_EMMC>;
> +		assigned-clock-rates = <200000000>;
> +		phys = <&emmc_phy>;
> +		phy-names = "phy_arasan";
> +		status = "disabled";
> +	};
>


-- 
Best Regards
Shawn Lin

  reply	other threads:[~2016-06-14  0:34 UTC|newest]

Thread overview: 33+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2016-06-13 23:04 [PATCH v2 0/11] Changes to support 150 MHz eMMC on rk3399 Douglas Anderson
2016-06-13 23:04 ` [PATCH v2 01/11] phy: rockchip-emmc: Increase lock time allowance Douglas Anderson
2016-06-14  0:28   ` Shawn Lin
2016-06-20 13:03   ` Kishon Vijay Abraham I
2016-06-13 23:04 ` [PATCH v2 02/11] mmc: sdhci-of-arasan: Always power the PHY off/on when clock changes Douglas Anderson
2016-06-14  0:30   ` Shawn Lin
2016-06-13 23:04 ` [PATCH v2 03/11] Documentation: mmc: sdhci-of-arasan: Add soc-ctl-syscon for corecfg regs Douglas Anderson
2016-06-14  0:33   ` Shawn Lin [this message]
2016-06-18 14:15   ` Heiko Stübner
2016-06-13 23:04 ` [PATCH v2 04/11] mmc: sdhci-of-arasan: Properly set corecfg_baseclkfreq on rk3399 Douglas Anderson
2016-06-18 17:59   ` Heiko Stuebner
2016-06-13 23:04 ` [PATCH v2 05/11] arm64: dts: rockchip: Add soc-ctl-syscon to sdhci for rk3399 Douglas Anderson
2016-06-18 12:49   ` Heiko Stübner
2016-06-13 23:04 ` [PATCH v2 06/11] Documentation: mmc: sdhci-of-arasan: Add ability to export card clock Douglas Anderson
2016-06-18 18:02   ` Heiko Stuebner
2016-06-13 23:04 ` [PATCH v2 07/11] " Douglas Anderson
2016-06-15 16:40   ` Doug Anderson
2016-06-13 23:04 ` [PATCH v2 08/11] Documentation: phy: Let the rockchip eMMC PHY get an exported " Douglas Anderson
2016-06-16 18:42   ` Rob Herring
2016-06-18 21:48   ` Heiko Stübner
2016-06-20 13:04   ` Kishon Vijay Abraham I
2016-06-13 23:04 ` [PATCH v2 09/11] phy: rockchip-emmc: Minor code cleanup in rockchip_emmc_phy_power_on/off() Douglas Anderson
2016-06-14  0:36   ` Shawn Lin
2016-06-20 13:04   ` Kishon Vijay Abraham I
2016-06-13 23:04 ` [PATCH v2 10/11] phy: rockchip-emmc: Set phyctrl_frqsel based on card clock Douglas Anderson
2016-06-18 12:20   ` Heiko Stübner
2016-06-20 16:48     ` Doug Anderson
2016-06-20 13:08   ` Kishon Vijay Abraham I
2016-06-13 23:04 ` [PATCH v2 11/11] arm64: dts: rockchip: Provide emmcclk to PHY for rk3399 Douglas Anderson
2016-06-18 12:07   ` Heiko Stübner
2016-06-16 23:39 ` [PATCH v2 0/11] Changes to support 150 MHz eMMC on rk3399 Heiko Stuebner
2016-06-17 12:39 ` Kishon Vijay Abraham I
2016-06-17 15:37   ` Doug Anderson

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=39b13297-782e-043f-96d3-95643f188f31@rock-chips.com \
    --to=shawn.lin@rock-chips.com \
    --cc=adrian.hunter@intel.com \
    --cc=briannorris@chromium.org \
    --cc=devicetree@vger.kernel.org \
    --cc=dianders@chromium.org \
    --cc=galak@codeaurora.org \
    --cc=heiko@sntech.de \
    --cc=ijc+devicetree@hellion.org.uk \
    --cc=kishon@ti.com \
    --cc=linux-kernel@vger.kernel.org \
    --cc=linux-mmc@vger.kernel.org \
    --cc=linux-rockchip@lists.infradead.org \
    --cc=mark.rutland@arm.com \
    --cc=pawel.moll@arm.com \
    --cc=robh+dt@kernel.org \
    --cc=ulf.hansson@linaro.org \
    --cc=xzy.xu@rock-chips.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox

all inboxes | Powered by JetHome®