Re: [1/3] drm/mediatek: Adjust the timing of mipi signal from LP00 to LP11

[CK Hu <ck.hu@mediatek.com>]

Hi, Xinlei:

On Fri, 2022-02-11 at 22:30 +0800, xinlei.lee@mediatek.com wrote:
> From: Jitao Shi <jitao.shi@mediatek.com>
> 
> In order to cooperate with patch 3/3 modification,it is necessary to
> adjust 
> the position where mipi pulls up the signal.

After the patch is applied, the series index (3/3) is disappear, so do
not reference series index in commit description. I think this series
is to adjust the calling sequence, so you could describe as below:

Old sequence:
1. aaa
2. bbb
3. ccc
4. ddd

New sequence:
1. bbb
2. aaa
3. ddd
4. ccc

and this patch is to adjust 'aaa' and 'bbb'.

Regards,
CK

> 
> Signed-off-by: Jitao Shi <jitao.shi@mediatek.com>
> Signed-off-by: Xinlei Lee <xinlei.lee@mediatek.com>
> ---
>  drivers/gpu/drm/mediatek/mtk_dsi.c | 6 +++---
>  1 file changed, 3 insertions(+), 3 deletions(-)
> 
> diff --git a/drivers/gpu/drm/mediatek/mtk_dsi.c
> b/drivers/gpu/drm/mediatek/mtk_dsi.c
> index 5d90d2eb..6d7b66d 100644
> --- a/drivers/gpu/drm/mediatek/mtk_dsi.c
> +++ b/drivers/gpu/drm/mediatek/mtk_dsi.c
> @@ -649,14 +649,14 @@ static int mtk_dsi_poweron(struct mtk_dsi *dsi)
>  	mtk_dsi_reset_engine(dsi);
>  	mtk_dsi_phy_timconfig(dsi);
>  
> -	mtk_dsi_rxtx_control(dsi);
> -	usleep_range(30, 100);
> -	mtk_dsi_reset_dphy(dsi);
>  	mtk_dsi_ps_control_vact(dsi);
>  	mtk_dsi_set_vm_cmd(dsi);
>  	mtk_dsi_config_vdo_timing(dsi);
>  	mtk_dsi_set_interrupt_enable(dsi);
>  
> +	mtk_dsi_rxtx_control(dsi);
> +	usleep_range(30, 100);
> +	mtk_dsi_reset_dphy(dsi);
>  	mtk_dsi_clk_ulp_mode_leave(dsi);
>  	mtk_dsi_lane0_ulp_mode_leave(dsi);
>  	mtk_dsi_clk_hs_mode(dsi, 0);