Re: [net-next 1/2] net: ethernet: slicoss: add slicoss gigabit ethernet driver

[Florian Fainelli <f.fainelli@gmail.com>]

On 11/15/2016 02:34 PM, Lino Sanfilippo wrote:
> On 15.11.2016 22:59, Andrew Lunn wrote:
>>> The link state is retrieved by a command to the application processor that is running 
>>> on the network card. Also the register to set the phy configuration is write-only, so
>>> it is not even possible to do the usual mdio bit-banging in the Phy read() and write()
>>> functions (however there seems to be another application processor command reserved 
>>> for retrieving the PHY settings, but I have not tried it yet). 
>>
>>>> +  			val = MII_BMCR << 16 | SLIC_PCR_AUTONEG |
>>>> +		     	         SLIC_PCR_AUTONEG_RST;
>>>> +			slic_write(sdev, SLIC_REG_WPHY, val);
>>
>> This actually looks a lot like an MDIO write operation. The upper 16
>> bits are the register, and the lower 16 bits are the data. What you
>> don't have is the address. But maybe it is limited to one address.
>>
>> If the processor command reserved for read works in a similar way, you
>> have enough to do an MDIO bus.
>>
> 
> Ok, I will give it a try. Reading values via the application processor
> is a bit awkward though, since it requires an address to a dma area as part of
> the command and then the AP informs the driver via irq that the dma memory has 
> been written. So probably the irq handler will have to set some flag and
> the mdio_read() function will have to poll for that flag in place of doing 
> bit-banging a register. 

That's a bit unusual compared to typical controllers that are usually
memory-mapped and that you can either write to, read/poll to know about
completion. I suppose that you could still have a mdiobus implementation
that is able to read to/from PHYs by submitting a command to the AP,
wait on a completion structure, and have the interrupt handler do the
completion of the command?
-- 
Florian