[PATCH] cxacru: Use a bulk URB to access the command endpoint

[Simon Arlott <simon@fire.lp0.eu>]

The command endpoint is a bulk endpoint, but interrupt transfers
are used to access it when checking status, load firmware or alter
the configuration.

This causes an error if CONFIG_USB_DEBUG is enabled after commit
f661c6f8c67bd55e93348f160d590ff9edf08904, which checks for this
mismatch.

Signed-off-by: Simon Arlott <simon@fire.lp0.eu>
---
 drivers/usb/atm/cxacru.c |   14 +++++++-------
 1 files changed, 7 insertions(+), 7 deletions(-)

diff --git a/drivers/usb/atm/cxacru.c b/drivers/usb/atm/cxacru.c
index 593fc5e..3b45f57 100644
--- a/drivers/usb/atm/cxacru.c
+++ b/drivers/usb/atm/cxacru.c
@@ -49,7 +49,7 @@
 
 static const char cxacru_driver_name[] = "cxacru";
 
-#define CXACRU_EP_CMD		0x01	/* Bulk/interrupt in/out */
+#define CXACRU_EP_CMD		0x01	/* Bulk in/out */
 #define CXACRU_EP_DATA		0x02	/* Bulk in/out */
 
 #define CMD_PACKET_SIZE		64	/* Should be maxpacket(ep)? */
@@ -1171,15 +1171,15 @@ static int cxacru_bind(struct usbatm_data *usbatm_instance,
 		goto fail;
 	}
 
-	usb_fill_int_urb(instance->rcv_urb,
-			usb_dev, usb_rcvintpipe(usb_dev, CXACRU_EP_CMD),
+	usb_fill_bulk_urb(instance->rcv_urb,
+			usb_dev, usb_rcvbulkpipe(usb_dev, CXACRU_EP_CMD),
 			instance->rcv_buf, PAGE_SIZE,
-			cxacru_blocking_completion, &instance->rcv_done, 1);
+			cxacru_blocking_completion, &instance->rcv_done);
 
-	usb_fill_int_urb(instance->snd_urb,
-			usb_dev, usb_sndintpipe(usb_dev, CXACRU_EP_CMD),
+	usb_fill_bulk_urb(instance->snd_urb,
+			usb_dev, usb_sndbulkpipe(usb_dev, CXACRU_EP_CMD),
 			instance->snd_buf, PAGE_SIZE,
-			cxacru_blocking_completion, &instance->snd_done, 4);
+			cxacru_blocking_completion, &instance->snd_done);
 
 	mutex_init(&instance->cm_serialize);
 
-- 
1.7.0.4
-- 
Simon Arlott