Re: [PATCH v2] pinctrl: qcom: nord: Split QUP1 SE2/SE3 into lane-pair functions

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 8/30/26 5:02 AM, Shawn Guo wrote:
> QUP1 SE2 and SE3 pack all four of their lanes pair-wise onto only two
> pins each: lanes 0/1 (I2C SDA/SCL) at mux value 2 and lanes 2/3 (UART
> TX/RX) at mux value 1, on gpio127/gpio128 and gpio129/gpio130
> respectively.
> 
> Both mux values were named "qup1_se2" (respectively "qup1_se3"), so the
> two distinct lane pairs became indistinguishable. msm_pinmux_set_mux()
> stops at the first entry matching the requested function, which means
> mux value 1 was always selected and the I2C lanes could never be muxed
> out. In practice i2c9 and i2c10 got the UART lanes and did not work,
> while uart9 and uart10 happened to be muxed correctly.
> 
> Give each lane pair its own function, following the _01/_23 naming
> already used for the same hardware arrangement by the shikra, eliza,
> hawi and maili TLMM drivers. Both functions still cover the full pin
> pair, so a single pinctrl state per protocol remains sufficient.
> 
> Drop gpio129/gpio130 from the SE2 group list, since those pins
> belong to SE3 and were never reachable through the SE2 function.
> 
> Also rename QUP1 SE2/SE3 functions in the binding doc accordingly.
> 
> While at it, add missing "gpio", "qup3_se0_mira" and "qup3_se0_mirb"
> to the binding function enum to get the list complete.
> 
> Fixes: c24dd0826f06 ("pinctrl: qcom: add the TLMM driver for the Nord platforms")
> Cc: stable@vger.kernel.org
> Assisted-by: LLM
> Signed-off-by: Shawn Guo <shengchao.guo@oss.qualcomm.com>
> ---

Reviewed-by: Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>

Konrad