Re: [PATCH v4 1/8] dt-bindings: counter: Add new ti,am62-eqep compatible

[Krzysztof Kozlowski <krzysztof.kozlowski@linaro.org>]

On 10/06/2024 16:46, Judith Mendez wrote:
> Add new compatible ti,am62-eqep for TI K3 devices. If a device
> uses this compatible, require power-domains property.
> 
> Since there is only one functional and interface clock for eqep,
> clock-names is not really required, so removed from required
> section, make it optional for ti,am3352-eqep compatible, and
> update the example.
> 

...


>          interrupts = <79>;
>      };
>  
> +  - |
> +    #include <dt-bindings/interrupt-controller/irq.h>
> +    #include <dt-bindings/interrupt-controller/arm-gic.h>
> +    #include <dt-bindings/soc/ti,sci_pm_domain.h>
> +
> +    bus {
> +        #address-cells = <2>;
> +        #size-cells = <2>;
> +        eqep1: counter@23210000 {

No need for label

> +          compatible = "ti,am62-eqep";
> +          reg = <0x00 0x23210000 0x00 0x100>;
> +          power-domains = <&k3_pds 60 TI_SCI_PD_EXCLUSIVE>;
> +          clocks = <&k3_clks 60 0>;
> +          interrupts = <GIC_SPI 117 IRQ_TYPE_EDGE_RISING>;
> +          status = "disabled";

Drop... which also points to another comment - since this was no-op and
example is basically the same, then just don't add it. No point.

> +        };
> +    };
>  ...

Best regards,
Krzysztof