Re: [PATCH v2 2/2] thermal: qcom: tsens: Disable wakeup interrupt setup on automotive targets

[Daniel Lezcano <daniel.lezcano@oss.qualcomm.com>]

On 6/3/26 14:25, Konrad Dybcio wrote:
> 
> 
> On 01-Jun-26 08:37, Priyansh Jain wrote:
>> Add a no_irq_wake flag to struct tsens_plat_data to allow platforms
>> to control whether TSENS interrupts should be configured as wakeup
>> sources.
>>
>> Create a new data_automotive structure and add compatible strings for
>> automotive TSENS variants (SA8775P, SA8255P) with wakeup interrupts
>> disabled.
>>
>> Automotive platforms can enter a low-power parking suspend state where the
>> application processors and thermal mitigation paths are not active. In this
>> state, waking the system due to TSENS threshold interrupts does not enable
>> useful thermal action, but it does repeatedly break suspend residency and
>> increase battery drain.
>>
>> Allow these automotive variants to keep TSENS monitoring enabled during
>> normal runtime while opting out of TSENS wakeup interrupts during suspend,
>> so the system can remain in low power until ignition/resume.
> 
> Can you not just disable the wakeup source via sysfs for
> your needs?

AFAIU, the system will crash for this version, so it has to be disabled