Re: [PATCH v2 2/2] thermal: qcom: tsens: Disable wakeup interrupt setup on automotive targets

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 6/3/26 2:27 PM, Daniel Lezcano wrote:
> On 6/3/26 14:25, Konrad Dybcio wrote:
>>
>>
>> On 01-Jun-26 08:37, Priyansh Jain wrote:
>>> Add a no_irq_wake flag to struct tsens_plat_data to allow platforms
>>> to control whether TSENS interrupts should be configured as wakeup
>>> sources.
>>>
>>> Create a new data_automotive structure and add compatible strings for
>>> automotive TSENS variants (SA8775P, SA8255P) with wakeup interrupts
>>> disabled.
>>>
>>> Automotive platforms can enter a low-power parking suspend state where the
>>> application processors and thermal mitigation paths are not active. In this
>>> state, waking the system due to TSENS threshold interrupts does not enable
>>> useful thermal action, but it does repeatedly break suspend residency and
>>> increase battery drain.
>>>
>>> Allow these automotive variants to keep TSENS monitoring enabled during
>>> normal runtime while opting out of TSENS wakeup interrupts during suspend,
>>> so the system can remain in low power until ignition/resume.
>>
>> Can you not just disable the wakeup source via sysfs for
>> your needs?
> 
> AFAIU, the system will crash for this version, so it has to be disabled

I can't see a mention of this in the commit message, but if it's the case,
it should most definitely be there in writing..

Konrad