Re: [PATCH v2] arm64: dts: qcom: glymur-crd: Move common board nodes to shared DTSI

[Pankaj Patil <pankaj.patil@oss.qualcomm.com>]

On 6/8/2026 3:33 PM, Gopikrishna Garmidi wrote:
> 
> 
> On 5/19/2026 7:55 PM, Gopikrishna Garmidi wrote:
>> The Glymur and Mahua CRDs use the same board-level hardware for the
>> eDP display panel, MDSS DP3 controller and PHY, USB-C ports (via
>> pmic-glink), USB 0/1/HS/MP controllers, QMP PHYs, eUSB2 repeaters,
>> HID peripherals (touchpad, keyboard, touchscreen) and their dependent
>> regulators and pin control states. This has been verified against
>> both CRD schematics.
>>
>> Move these nodes from glymur-crd.dts to glymur-crd.dtsi to enable code
>> reuse with the Mahua CRD.
>>
>> Signed-off-by: Gopikrishna Garmidi <gopikrishna.garmidi@oss.qualcomm.com>
>> ---
>> Changes in v2:
>> - Rebased on top of next-20260518
>> - Updated subject to include glymur-crd scope prefix
>> - Rewrote commit message to describe the actual shared physical hardware
>>    rather than the code-sharing intent; the commonality was verified
>>    against Glymur CRD and Mahua CRD schematics
>> - Link to v1: https://lore.kernel.org/r/20260326-glymur-mahua-common-nodes-v1-1-12bb26920ea4@oss.qualcomm.com
>> ---
>>   arch/arm64/boot/dts/qcom/glymur-crd.dts  | 399 -------------------------------
>>   arch/arm64/boot/dts/qcom/glymur-crd.dtsi | 396 ++++++++++++++++++++++++++++++
>>   2 files changed, 396 insertions(+), 399 deletions(-)
> 
>  
> Hi Krzysztof, Konrad,
> 
> This has been waiting for a while now and already has a Reviewed-by from Dmitry. Could you take a look when you get a chance?
> 
> Thanks,
> Gopikrishna Garmidi

Krzystof,
We've verified from the schematics the soc gpio and other lines do not change and are pin to pin compatible with glymur,
The only change are the external peripherals connected

Thanks,
Pankaj

Reviewed-by: Pankaj Patil <pankaj.patil@oss.qualcomm.com>