Re: [PATCH v6 09/10] drm/msm/dp: turn link_ready into plugged

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 5/24/26 12:33 PM, Dmitry Baryshkov wrote:
> Tracking when the DP link is ready isn't that useful from the driver
> point of view. It doesn't provide a direct information if the device
> should be suspended, etc. Replace it with the 'plugged' boolean, which
> is set when the driver knows that there is DPRX plugged.
> 
> Tested-by: Val Packett <val@packett.cool> # x1e80100-dell-latitude-7455
> Tested-by: Yongxing Mou <yongxing.mou@oss.qualcomm.com> # Hamoa IOT EVK, QCS8300 Ride
> Signed-off-by: Dmitry Baryshkov <dmitry.baryshkov@oss.qualcomm.com>
> ---

[...]

> -static void msm_dp_display_host_phy_init(struct msm_dp_display_private *dp)
> +/**
> + * msm_dp_display_host_phy_init() - start up DP PHY
> + * @dp: main display data structure
> + *
> + * Prepare DP PHY for the AUX transactions to succeed.
> + *
> + * Returns: true if this call has initliazed the PHY and false if the PHY has
> + * already been setup beforehand.

This assumes no failure. I hope adding various return-value checks across
this driver is somewhere on the todolist..

[...]

>  end:
> -	pm_runtime_put_sync(&dp->pdev->dev);
> +	/*
> +	 * If we detected the DPRX, leave the controller on so that it doesn't
> +	 * loose the state.

"lose"

That is done.. presumably so that one could correct a coredump or similar?

Konrad