RE: [PATCH v12 2/9] dt-bindings: reset: Add bindings for SP7021 reset driver

["qinjian[覃健]" <qinjian@cqplus1.com>]

> 
> On Thu, Mar 31, 2022 at 10:29 AM Qin Jian <qinjian@cqplus1.com> wrote:
> 
> > +/* mo_reset0 ~ mo_reset9 */
> > +#define RST_SYSTEM             0x00
> > +#define RST_RTC                        0x02
> > +#define RST_IOCTL              0x03
> > +#define RST_IOP                        0x04
> > +#define RST_OTPRX              0x05
> > +#define RST_NOC                        0x06
> > +#define RST_BR                 0x07
> > +#define RST_RBUS_L00           0x08
> > +#define RST_SPIFL              0x09
> > +#define RST_SDCTRL0            0x0a
> > +#define RST_PERI0              0x0b
> > +#define RST_A926               0x0d
> > +#define RST_UMCTL2             0x0e
> > +#define RST_PERI1              0x0f
> > +
> > +#define RST_DDR_PHY0           0x10
> > +#define RST_ACHIP              0x12
> > +#define RST_STC0               0x14
> > +#define RST_STC_AV0            0x15
> > +#define RST_STC_AV1            0x16
> > +#define RST_STC_AV2            0x17
> 
> The list looks like these definitions just match the hardware, which means you
> don't have to define them as a binding at all, just use the hardware numbers
> directly in the dt, as you do for interrupts or gpio numbers.
> 
> If the hardware does not have a sane way of mapping reset lines to a particular
> hardware number, then you may have to define a binding, but in that case just
> use consecutive integer numbers, not hexadecimal numbers.
> 
>        Arnd

You are right, these definitions does match the hardware, In reset-sunplus.c:
static int sp_reset_status(struct reset_controller_dev *rcdev,
                           unsigned long id)
{
        struct sp_reset *reset = to_sp_reset(rcdev);
        int index = id / BITS_PER_HWM_REG;
        int shift = id % BITS_PER_HWM_REG;
        u32 reg;

        reg = readl(reset->base + (index * 4));

        return !!(reg & BIT(shift));
}
the 'id'  is these value passed from dt.

I'll remove this file & update dt, thanks for your comments.