Re: [net-next PATCH v4 2/8] net: dsa: realtek: rtl8365mb: use dsa helpers for port iteration

[Mieczyslaw Nalewaj <namiltd@yahoo.com>]

On 5/16/2026 5:46 AM, Luiz Angelo Daros de Luca wrote:
> Use dsa_switch_for_each_*() whenever possible.
> 
> For port setup(), a new blocking setup phase was added for all ports,
> including unused ones, before the user and CPU port setup.
> 
> CPU isolation includes all user ports as traffic was being blocked in
> some scenarios (suggested by Abdulkader Alrezej).
> 
> The driver bails out if a DSA port is detected as the driver was not
> tested in a cascading setup.
> 
> Suggested-by: Abdulkader Alrezej <abdulkader.alrezej@gmail.com>
> Reviewed-by: Linus Walleij <linusw@kernel.org>
> Signed-off-by: Luiz Angelo Daros de Luca <luizluca@gmail.com>
> ---> [...]> @@ -1974,46 +1978,83 @@ static int rtl8365mb_setup(struct dsa_switch *ds)
>  	else if (ret)
>  		dev_info(priv->dev, "no interrupt support\n");
>  
> -	/* Configure CPU tagging */
> -	dsa_switch_for_each_cpu_port(cpu_dp, ds) {
> -		cpu->mask |= BIT(cpu_dp->index);
> +	/* Start with all ports blocked, including unused ports */
> +	dsa_switch_for_each_port(dp, ds) {
> +		struct rtl8365mb_port *p = &mb->ports[dp->index];
>  
> -		if (cpu->trap_port == RTL8365MB_MAX_NUM_PORTS)
> -			cpu->trap_port = cpu_dp->index;
> -	}
> -	cpu->enable = cpu->mask > 0;
> -	ret = rtl8365mb_cpu_config(priv);
> -	if (ret)
> -		goto out_teardown_irq;
> -
> -	/* Configure ports */
> -	for (i = 0; i < priv->num_ports; i++) {
> -		struct rtl8365mb_port *p = &mb->ports[i];
> +		if (dsa_port_is_dsa(dp)) {
> +			dev_err(ds->dev, "Cascading (DSA links) not supported");
> +			return -EOPNOTSUPP;
> +		}
>  
Missing trailing \n in the format string. Kernel dev_err() messages aren't auto-newlined by the logging machinery — without one, this line will be glued to whatever subsequent printk follows. Every other dev_err/dev_info in this driver (e.g. the dev_info(priv->dev, "no interrupt support\n"); a few lines above) terminates with \n