[Question] should we export set_suspend_voltage()?

["Yi Zhang" <yizhanghust@163.com>]

[-- Warning: decoded text below may be mangled, UTF-8 assumed --]
[-- Attachment #1: Type: text/plain; charset=UTF-8, Size: 1183 bytes --]


Hi, Liam & Mark:


seems at present, the set_suspend_voltage() is designed to cover the suspend voltage handling from board level, when the system enters into the suspend;
but the behavior of my chip is as following:
a) there are two sets of registers to configure one regulator's voltage separately, one is for active mode, the other is for the low power mode, say, suspend-to-ram;
b) both of the sets have control bits independently;
c) once the low power mode is triggered, by external signal, for example, pull-down a gpio, the regulator switches to use the registers for low power mode;
d) the consumers have different requirements for the voltage in low power mode according to different scenario, IOW, we cannot assume a fix value when system boots up;

So 
do you think it's good to export the set_suspend_voltage()? to make it controllable by the regulator itself?
another method in my opinion is add a set of virtual-regulator for this usage?

could you please share your advice?

thanks very much;

--
Yi Zhangÿôèº{.nÇ+‰·Ÿ®‰­†+%ŠËÿ±éݶ\x17¥Šwÿº{.nÇ+‰·¥Š{±þG«éÿŠ{ayº\x1dʇڙë,j\a­¢f£¢·hšïêÿ‘êçz_è®\x03(­éšŽŠÝ¢j"ú\x1a¶^[m§ÿÿ¾\a«þG«éÿ¢¸?™¨è­Ú&£ø§~á¶iO•æ¬z·švØ^\x14\x04\x1a¶^[m§ÿÿÃ\fÿ¶ìÿ¢¸?–I¥