Re: [PATCH v2 1/2] dt-bindings: net: Convert ATH10K to YAML

[Konrad Dybcio <konrad.dybcio@linaro.org>]

On 6.04.2023 14:47, Rob Herring wrote:
> 
> On Thu, 06 Apr 2023 13:54:04 +0200, Konrad Dybcio wrote:
>> Convert the ATH10K bindings to YAML.
>>
>> Dropped properties that are absent at the current state of mainline:
>> - qcom,msi_addr
>> - qcom,msi_base
>>
>> qcom,coexist-support and qcom,coexist-gpio-pin do very little and should
>> be reconsidered on the driver side, especially the latter one.
>>
>> Somewhat based on the ath11k bindings.
>>
>> Signed-off-by: Konrad Dybcio <konrad.dybcio@linaro.org>
>> ---
>>  .../bindings/net/wireless/qcom,ath10k.txt          | 215 ------------
>>  .../bindings/net/wireless/qcom,ath10k.yaml         | 359 +++++++++++++++++++++
>>  2 files changed, 359 insertions(+), 215 deletions(-)
>>
> 
> My bot found errors running 'make DT_CHECKER_FLAGS=-m dt_binding_check'
> on your patch (DT_CHECKER_FLAGS is new in v5.13):
> 
> yamllint warnings/errors:
> 
> dtschema/dtc warnings/errors:
> /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.example.dtb: wifi@18800000: wifi-firmware: 'wifi-firmware' does not match any of the regexes: 'pinctrl-[0-9]+'
> 	From schema: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.yaml
> /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.example.dtb: wifi@18800000: wifi-firmware: 'iommus' is a required property
> 	From schema: /builds/robherring/dt-review-ci/linux/Documentation/devicetree/bindings/net/wireless/qcom,ath10k.yaml
> 
> doc reference errors (make refcheckdocs):
> MAINTAINERS: Documentation/devicetree/bindings/net/wireless/qcom,ath10k.txt
> 
> See https://patchwork.ozlabs.org/project/devicetree-bindings/patch/20230406-topic-ath10k_bindings-v2-1-557f884a65d1@linaro.org
Oh, CHECK_DTBS=1 doesn't run dt_binding_check and I didn't run that
explicitly before resending.. my bad..

Konrad
> 
> The base for the series is generally the latest rc1. A different dependency
> should be noted in *this* patch.
> 
> If you already ran 'make dt_binding_check' and didn't see the above
> error(s), then make sure 'yamllint' is installed and dt-schema is up to
> date:
> 
> pip3 install dtschema --upgrade
> 
> Please check and re-submit after running the above command yourself. Note
> that DT_SCHEMA_FILES can be set to your schema file to speed up checking
> your schema. However, it must be unset to test all examples with your schema.
>