Re: [PATCH] drm/ssd130x: Set SPI .id_table to prevent an SPI core warning

[Javier Martinez Canillas <javierm@redhat.com>]

Javier Martinez Canillas <javierm@redhat.com> writes:

> Dmitry Baryshkov <dmitry.baryshkov@linaro.org> writes:
>
>> On Tue, Dec 31, 2024 at 04:34:34PM +0100, Javier Martinez Canillas wrote:
>>> Dmitry Baryshkov <dmitry.baryshkov@linaro.org> writes:
>>> 
>>> Hello Dmitry,
>>> 
>>> > On Tue, Dec 31, 2024 at 12:44:58PM +0100, Javier Martinez Canillas wrote:
>>
>> [...]
>>
>>> >> Since the check is done even for built-in drivers, drop the condition to
>>> >> only define the ID table when the driver is built as a module. Finally,
>>> >> rename the variable to use the "_spi_id" convention used for ID tables.
>>> >> 
>>> >> Signed-off-by: Javier Martinez Canillas <javierm@redhat.com>
>>> >
>>> > Fixes: 74373977d2ca ("drm/solomon: Add SSD130x OLED displays SPI support")
>>> >
>>> 
>>> I was on the fence about adding a Fixes: tag due a) the issue being there
>>> from the beginning as you pointed out and b) the warning being harmless.
>>> 
>>> But I'll add it to v2 or just before pushing it to drm-misc-next.
>>
>> Just before pushing is enough. dim b4-shazam can do that for you.
>>
>
> Yeah, I meant in case that I post a v2. I'll wait a few days before
> pushing in case someone else chimes in. Thanks again!
>

Pushed to drm-misc (drm-misc-next). Thanks!

-- 
Best regards,

Javier Martinez Canillas
Core Platforms
Red Hat