Re: [PATCH] soundwire: qcom: Update error prints to debug prints

[Srinivasa Rao Mandadapu <quic_srivasam@quicinc.com>]

On 7/13/2022 7:53 PM, Pierre-Louis Bossart wrote:
Thanks for your time Pierre-Louis!!!
>
> On 7/13/22 07:22, Srinivasa Rao Mandadapu wrote:
>> Upadte error prints to debug prints to avoid redundant logging in kernel
> update
Okay. Will change it.
>
>> boot time, as these prints are informative prints in irq handler.
>>
>> Signed-off-by: Srinivasa Rao Mandadapu <quic_srivasam@quicinc.com>
>> ---
>>   drivers/soundwire/qcom.c | 5 ++---
>>   1 file changed, 2 insertions(+), 3 deletions(-)
>>
>> diff --git a/drivers/soundwire/qcom.c b/drivers/soundwire/qcom.c
>> index 9df970e..a4293d0 100644
>> --- a/drivers/soundwire/qcom.c
>> +++ b/drivers/soundwire/qcom.c
>> @@ -573,11 +573,10 @@ static irqreturn_t qcom_swrm_irq_handler(int irq, void *dev_id)
>>   				break;
>>   			case SWRM_INTERRUPT_STATUS_NEW_SLAVE_ATTACHED:
>>   			case SWRM_INTERRUPT_STATUS_CHANGE_ENUM_SLAVE_STATUS:
>> -				dev_err_ratelimited(swrm->dev, "%s: SWR new slave attached\n",
>> -					__func__);
>> +				dev_dbg(swrm->dev, "%s: SWR new slave attached\n", __func__);
> any reason why the rate limitation was dropped?
No Specific Reason as such. Will add ratelimited and re-spin it.
>
>>   				swrm->reg_read(swrm, SWRM_MCP_SLV_STATUS, &slave_status);
>>   				if (swrm->slave_status == slave_status) {
>> -					dev_err(swrm->dev, "Slave status not changed %x\n",
>> +					dev_dbg(swrm->dev, "Slave status not changed %x\n",
>>   						slave_status);
>>   				} else {
>>   					qcom_swrm_get_device_status(swrm);