Re: [PATCH v8 8/8] arm64: dts: qcom: kodiak: Desribe EUD UTMI routing and connector mapping

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 9/13/26 12:53 AM, Elson Serrao wrote:
> The existing EUD description uses a legacy single-path representation
> that assumes uniform UTMI routing. This was sufficient for minimal
> configurations where the USB port operated only in device mode and role
> switching was not considered.
> 
> Update the description to explicitly model the topology using eud path
> child node and add a role-switch declaration to reflect role-dependent
> UTMI routing. Also on this SoC, the EUD hardware intercepts only the
> primary UTMI path. So remove the USB endpoint mapping to the secondary
> controller and associate it with the primary controller.
> 
> With the intermediate EUD node now in place, update the Kodiak board
> descriptions to map the USB connector endpoint to the EUD instead of
> directly to the USB controller, reflecting the intended hardware
> topology. Enable the EUD by default now that the complete topology is
> described.
> 
> Signed-off-by: Elson Serrao <elson.serrao@oss.qualcomm.com>
> ---

[...]

> diff --git a/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts b/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
> index f41ad446a39e..b1f1ff6b99e6 100644
> --- a/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
> +++ b/arch/arm64/boot/dts/qcom/qcm6490-fairphone-fp5.dts
> @@ -98,7 +98,7 @@ port@0 {
>  					reg = <0>;
>  
>  					pmic_glink_hs_in: endpoint {
> -						remote-endpoint = <&usb_1_dwc3_hs>;
> +						remote-endpoint = <&eud_con>;
>  					};
>  				};
>  
> @@ -1530,10 +1530,6 @@ &usb_1 {
>  	status = "okay";
>  };
>  
> -&usb_1_dwc3_hs {
> -	remote-endpoint = <&pmic_glink_hs_in>;
> -};
> -
>  &usb_1_hsphy {
>  	vdda-pll-supply = <&vreg_l10c>;
>  	vdda18-supply = <&vreg_l1c>;
> @@ -1573,3 +1569,7 @@ &wifi {
>  	qcom,calibration-variant = "Fairphone_5";
>  	status = "okay";
>  };
> +
> +&eud_con {
> +	remote-endpoint = <&pmic_glink_hs_in>;
> +};

Label references should be sorted alphabetically within a file,
there may be slight deviations because the tooling to enforce
that is still under development, but let's try to not add more

Konrad