Re: [PATCH rtw-next v4 2/4] wifi: rtw88: sdio: Track running state and cancel TX worker on stop

["Luka Gejak" <luka.gejak@linux.dev>]

October 6, 2026 at 16:03, "Luka Gejak" <luka.gejak@linux.dev mailto:luka.gejak@linux.dev?to=%22Luka%20Gejak%22%20%3Cluka.gejak%40linux.dev%3E > wrote:


> 
> October 6, 2026 at 04:03, "Ping-Ke Shih" <pkshih@realtek.com mailto:pkshih@realtek.com?to=%22Ping-Ke%20Shih%22%20%3Cpkshih%40realtek.com%3E > wrote:
> 
> > 
> > Alastair D'Silva <alastair@d-silva.org> wrote:
> > 
[...]
> >  
> >  static void rtw_sdio_deep_ps_enter(struct rtw_dev *rtwdev)
> >  @@ -1470,6 +1476,9 @@ static void rtw_sdio_handle_interrupt(struct sdio_func *sdio_func)
> >  rtwdev = hw->priv;
> >  rtwsdio = (struct rtw_sdio *)rtwdev->priv;
> >  
> >  + if (!rtwsdio->running)
> >  + return;
> >  +
> > 
> I think we should keep this check too, per my explanation below.
> 

Correction, as I realized I didn't include explanation for this below.

Sorry for that, here is the explanation:

This check sits on the interrupt path, which the cancel does not
cover. rtw_sdio_stop() only masks HIMR. The SDIO IRQ is released in
rtw_sdio_free_irq():

sdio_release_irq(sdio_func);

and that only runs at remove. A request raised just before the mask
can still reach the handler once after a stop, and without the check
that run reads HISR and writes the ack back on a stopped device.

Best regards,
Luka Gejak