Re: [PATCH v3 2/7] dt-bindings: media: qcom,sm8150-camss: Add SM8150 CAMSS

[Andrew Gigena <mail@andrewgigena.dev>]

Hi Krzysztof,

First of all, apologies for the late reply and for not following your review
advice earlier - that was my mistake, and I should have responded to your v2
comments individually instead of letting them carry over.

I have now gone through your v2 and v3 comments again and addressed most of
them locally in a v4:
- reg/reg-names moved to the top, redundant minItems dropped, property order
  aligned with writing-schema.rst, example cleaned up, ports use
  patternProperties, bus-type dropped from the CAMSS binding, etc.

Regarding your v3 question about the order of reg/reg-names/interrupt-names
(vfe0, csid0, vfe1, csid1, ...): I took it from qcom,sc8280xp-camss.yaml,
which uses the same paired VFE/CSID layout and is the closest reference for
SM8150. The entries are also in ascending register-address order in the SoC DTS.

If you would prefer a different grouping (e.g. all CSIDs then all VFEs, as in
sm8250), I can reorder the binding, DTS and driver resource table. Please let me
know which ordering you prefer. I would like to hear your feedback first so I
can adjust anything needed before sending v4.

Best regards,
Andrew