Re: [PATCH] clk: qcom: gcc-x1e80100: Don't use parking clk_ops for QUPs

[Bryan O'Donoghue <bryan.odonoghue@linaro.org>]

On 26/08/2024 14:44, Konrad Dybcio wrote:
> On 23.08.2024 2:58 PM, Bryan O'Donoghue wrote:
>> Per Stephen Boyd's explanation in the link below, QUP RCG clocks do not
>> need to be parked when switching frequency. A side-effect in parking to a
>> lower frequency can be a momentary invalid clock driven on an in-use serial
>> peripheral.
>>
>> This can cause "junk" to spewed out of a UART as a low-impact example. On
>> the x1e80100-crd this serial port junk can be observed on linux-next.
>>
>> Apply a similar fix to the x1e80100 Global Clock controller to remediate.
>>
>> Link: https://lore.kernel.org/all/20240819233628.2074654-3-swboyd@chromium.org/
>> Fixes: 161b7c401f4b ("clk: qcom: Add Global Clock controller (GCC) driver for X1E80100")
>> Fixes: 929c75d57566 ("clk: qcom: gcc-sm8550: Mark RCGs shared where applicable")
>> Suggested-by: Neil Armstrong <neil.armstrong@linaro.org>
>> Signed-off-by: Bryan O'Donoghue <bryan.odonoghue@linaro.org>
>> ---
>> I ran into some junk on the x1e80100 serial port and asked around to see if
>> someone had already found and fixed.
>>
>> Neil pointed me at Stephen's fix for sm8550 which I found is also required
>> to fix the same thing x1e80100.
>> ---
> 
> Reviewed-by: Konrad Dybcio <konradybcio@kernel.org>
> 
> Mind also fixing up 8650 that seems to have this issue?
> 
> Konrad

np