tg3 and bcm5703 cards - rx dropped packets

tg3 and bcm5703 cards - rx dropped packets

[Michael Di Domenico]

I have several Dell t3500 workstation which we've installed PCI-X
BroadCom cards specifically the BCM5703 Fiber cards.

We're also using RedHat v5.4 2.6.18-164.6.1 kernel with all the stock drivers.

For some reason which i cannot determine, when we read a large amount
of data into the workstation we see the RX dropped counter steadily
(rapidly) increase.

This only happens on reads, if we do a write operation we do not see TX drops.

We've tested this between all types of devices (nfs, http) servers at
various points in the network and the only common thing is the NIC.

I'd think it was just a bad nic, but we have several nics across t3500
and t3400's doing this.

Is anyone aware of such an issue?  Can anyone recommend some steps i
can take to isolate why the packets are being dropped?

I hooked up wireshark on one of the servers while we were running the
test and i see a lot of Duplicate ACK and TCP Checksum errors, in the
communications between the two hosts.  But im not sure that actually
points to anything.

Thanks

Re: tg3 and bcm5703 cards - rx dropped packets

[Teck Choon Giam]

Have you try one or all of the below?

/sbin/ethtool -K eth0 tx off
/sbin/ethtool -K eth0 rx off
/sbin/ethtool -K eth0 gso off
/sbin/ethtool -K eth0 tso off

Assuming eth0 is your interface.