* 2.6.1-rc1-mm1 - KGDB fails to breakpoint in Serial Mode
@ 2004-01-03 21:26 John Heil
0 siblings, 0 replies; only message in thread
From: John Heil @ 2004-01-03 21:26 UTC (permalink / raw)
To: linux-kernel
In 2.6.1-rc1-mm1, KGDB fails to generate breakpoints after the
initial one, in either built-in code or in modules.
I started the debug session as usual w
gdb vmlinux
The target then halts as expected in bootup
target remote /dev/ttyS0
c
causes boot to continue as expects
However, once running, the gdb break command against
the running kernel or a loaded module fails to result in a break.
The module start address was set as usual w add-symbol-file
which in turn matches cat /proc/modules.
I'll debug this myself if need be, but hopefully
there is some simple solution?
Thnx much,
johnh
-
-----------------------------------------------------------------
John Heil
South Coast Software
Custom systems software for UNIX and IBM MVS mainframes
1-714-774-6952
johnhscs@sc-software.com
http://www.sc-software.com
-----------------------------------------------------------------
^ permalink raw reply [flat|nested] only message in thread
only message in thread, other threads:[~2004-01-03 21:29 UTC | newest]
Thread overview: (only message) (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2004-01-03 21:26 2.6.1-rc1-mm1 - KGDB fails to breakpoint in Serial Mode John Heil
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®