* [PATCH] arm64: dts: qcom: talos-lyra-evk: fix sdhc_2 vqmmc-supply for UHS-I mode
@ 2026-10-28 12:18 Monish Chunara
2026-10-28 12:25 ` Konrad Dybcio
0 siblings, 1 reply; 2+ messages in thread
From: Monish Chunara @ 2026-10-28 12:18 UTC (permalink / raw)
To: Bjorn Andersson, Konrad Dybcio, Abel Vesa, Rob Herring,
Krzysztof Kozlowski, Conor Dooley
Cc: linux-arm-msm, devicetree, linux-kernel, Monish Chunara
SD card is detected as SDHS instead of UHS-I because sdhc_2 was
configured with vreg_s4a as vqmmc-supply, which cannot switch between
1.8V and 3.3V.
Switch vqmmc-supply to vreg_l2a and update its voltage range to
1800000-2960000 uV to enable proper UHS-I signaling.
Signed-off-by: Monish Chunara <monish.chunara@oss.qualcomm.com>
This patch depends on base series -
https://lore.kernel.org/all/20261027-talos-lyra-evk-v2-v3-2-658fd5a7ec99@oss.qualcomm.com/
---
arch/arm64/boot/dts/qcom/talos-lyra-evk-som.dtsi | 6 +++---
1 file changed, 3 insertions(+), 3 deletions(-)
diff --git a/arch/arm64/boot/dts/qcom/talos-lyra-evk-som.dtsi b/arch/arm64/boot/dts/qcom/talos-lyra-evk-som.dtsi
index 7d9a08471906..65a2ca78106d 100644
--- a/arch/arm64/boot/dts/qcom/talos-lyra-evk-som.dtsi
+++ b/arch/arm64/boot/dts/qcom/talos-lyra-evk-som.dtsi
@@ -57,8 +57,8 @@ vreg_l1a: ldo1 {
vreg_l2a: ldo2 {
regulator-name = "vreg_l2a";
- regulator-min-microvolt = <1650000>;
- regulator-max-microvolt = <3100000>;
+ regulator-min-microvolt = <1800000>;
+ regulator-max-microvolt = <2960000>;
regulator-initial-mode = <RPMH_REGULATOR_MODE_HPM>;
regulator-allow-set-load;
regulator-allowed-modes = <RPMH_REGULATOR_MODE_LPM
@@ -224,7 +224,7 @@ &sdhc_2 {
bus-width = <4>;
cd-gpios = <&tlmm 99 GPIO_ACTIVE_LOW>;
vmmc-supply = <&vreg_l10a>;
- vqmmc-supply = <&vreg_s4a>;
+ vqmmc-supply = <&vreg_l2a>;
status = "okay";
};
--
2.34.1
^ permalink raw reply [flat|nested] 2+ messages in thread
* Re: [PATCH] arm64: dts: qcom: talos-lyra-evk: fix sdhc_2 vqmmc-supply for UHS-I mode
2026-10-28 12:18 [PATCH] arm64: dts: qcom: talos-lyra-evk: fix sdhc_2 vqmmc-supply for UHS-I mode Monish Chunara
@ 2026-10-28 12:25 ` Konrad Dybcio
0 siblings, 0 replies; 2+ messages in thread
From: Konrad Dybcio @ 2026-10-28 12:25 UTC (permalink / raw)
To: Monish Chunara, Bjorn Andersson, Konrad Dybcio, Abel Vesa,
Rob Herring, Krzysztof Kozlowski, Conor Dooley
Cc: linux-arm-msm, devicetree, linux-kernel
On 10/28/26 1:18 PM, Monish Chunara wrote:
> SD card is detected as SDHS instead of UHS-I because sdhc_2 was
> configured with vreg_s4a as vqmmc-supply, which cannot switch between
> 1.8V and 3.3V.
>
> Switch vqmmc-supply to vreg_l2a and update its voltage range to
> 1800000-2960000 uV to enable proper UHS-I signaling.
>
> Signed-off-by: Monish Chunara <monish.chunara@oss.qualcomm.com>
>
> This patch depends on base series -
> https://lore.kernel.org/all/20261027-talos-lyra-evk-v2-v3-2-658fd5a7ec99@oss.qualcomm.com/
> ---
Please fix the base series then
Konrad
^ permalink raw reply [flat|nested] 2+ messages in thread
end of thread, other threads:[~2026-10-28 12:25 UTC | newest]
Thread overview: 2+ messages (download: mbox.gz / follow: Atom feed)
-- links below jump to the message on this page --
2026-10-28 12:18 [PATCH] arm64: dts: qcom: talos-lyra-evk: fix sdhc_2 vqmmc-supply for UHS-I mode Monish Chunara
2026-10-28 12:25 ` Konrad Dybcio
This is a public inbox, see mirroring instructions
for how to clone and mirror all data and code used for this inbox
all inboxes | Powered by JetHome®