Re: [PATCH v3 0/3] Enable ICE clock scaling

[Abhinaba Rakshit <abhinaba.rakshit@oss.qualcomm.com>]

On Fri, Jan 23, 2026 at 09:18:36PM +0200, Dmitry Baryshkov wrote:
> On Fri, Jan 23, 2026 at 12:42:11PM +0530, Abhinaba Rakshit wrote:
> > Introduce support for dynamic clock scaling of the ICE (Inline Crypto Engine)
> > using the OPP framework. During ICE device probe, the driver now attempts to
> > parse an optional OPP table from the ICE-specific device tree node to
> > determine minimum and maximum supported frequencies for DVFS-aware operations.
> > API qcom_ice_scale_clk is exposed by ICE driver and is invoked by UFS host
> > controller driver in response to clock scaling requests, ensuring coordination
> > between ICE and host controller.
> > 
> > For MMC controllers that do not support clock scaling, the ICE clock frequency
> > is kept aligned with the MMC controller’s clock rate (TURBO) to ensure
> > consistent operation.
> > 
> > Dynamic clock scaling based on OPP tables enables better power-performance
> > trade-offs. By adjusting ICE clock frequencies according to workload and power
> > constraints, the system can achieve higher throughput when needed and
> > reduce power consumption during idle or low-load conditions.
> > 
> > The OPP table remains optional, absence of the table will not cause
> > probe failure. However, in the absence of an OPP table, ICE clocks will
> > remain at their default rates, which may limit performance under
> > high-load scenarios or prevent performance optimizations during idle periods.
> > 
> > Signed-off-by: Abhinaba Rakshit <abhinaba.rakshit@oss.qualcomm.com>
> > ---
> > Changes in v3:
> > - Avoid clock scaling in case of legacy bindings as suggested.
> > - Use of_device_is_compatible to distinguish between legacy and non-legacy bindings.
> > - Link to v2: https://lore.kernel.org/r/20251121-enable-ufs-ice-clock-scaling-v2-0-66cb72998041@oss.qualcomm.com
> > 
> > Changes in v2:
> > - Use OPP-table instead of freq-table-hz for clock scaling.
> > - Enable clock scaling for legacy targets as well, by fetching frequencies from storage opp-table.
> > - Introduce has_opp variable in qcom_ice structure to keep track, if ICE instance has dedicated OPP-table registered.
> > - Combined the changes for patch-series <20251001-set-ice-clock-to-turbo-v1-1-7b802cf61dda@oss.qualcomm.com> as suggested.
> > - Link to v1: https://lore.kernel.org/r/20251001-enable-ufs-ice-clock-scaling-v1-0-ec956160b696@oss.qualcomm.com
> > 
> > ---
> > Abhinaba Rakshit (3):
> 
> DT binding changes should be a part of the same series.

Sure, will bring the dt-bindings change to this patchseries.