Re: [PATCH 1/2 v2] spi: add SPI_MOSI_IDLE_LOW support from device tree

[Marcelo Schmitt <marcelo.schmitt1@gmail.com>]

Hello Charles-Antoine,

On 03/29, charles-antoine.couret@mind.be wrote:
> From: Charles-Antoine Couret <charles-antoine.couret@mind.be>
> 
> This flag was introduced but was not added as device tree property which is
> limiting the possibility to use this flag on real devices.

I'm not seeing why a device tree property is needed for SPI idle modes. For
idling high, the configuration is requested through spi_setup(). It should
work in similar way for idling low. See spi-summary.rst. If believe a dt
property is needed despite the spi_setup() interface, can you elaborate on why?

> 
> This flag can be configured as done for other flags.
> 
> Signed-off-by: Charles-Antoine Couret <charles-antoine.couret@mind.be>
> ---
>  drivers/spi/spi.c | 2 ++
>  1 file changed, 2 insertions(+)
> 
> diff --git a/drivers/spi/spi.c b/drivers/spi/spi.c
> index 9b1125556d29..489a64e20305 100644
> --- a/drivers/spi/spi.c
> +++ b/drivers/spi/spi.c
> @@ -2363,6 +2363,8 @@ static int of_spi_parse_dt(struct spi_controller *ctlr, struct spi_device *spi,
>  		spi->mode |= SPI_LSB_FIRST;
>  	if (of_property_read_bool(nc, "spi-cs-high"))
>  		spi->mode |= SPI_CS_HIGH;
> +	if (of_property_read_bool(nc, "spi-mosi-idle-low"))
> +		spi->mode |= SPI_MOSI_IDLE_LOW;
>  
>  	/* Device DUAL/QUAD mode */
>  
> -- 
> 2.53.0
> 
> 

With best regards,
Marcelo