yenta: Fish. Please report.

yenta: Fish. Please report.

[Magnus Damm]

Hello,

I am unable to use yenta from 2.6.9 on my laptop.  The module loads
but "cardctl insert" and "cardctl status" does not work what I can
tell. 2.4.28 seems to work ok, so does 2.4.19.

The laptop model is uniwill 223ii0, BIOS 1.03. 

2.6.9-kernel output from "modprobe yenta_socket":

ACPI: PCI interrupt 0000:01:03.0[A] -> GSI 3 (level, low) -> IRQ 3
Yenta: CardBus bridge found at 0000:01:03.0 [1584:3200]
Yenta: Using CSCINT to route CSC interrupts to PCI
Yenta: Routing CardBus interrupts to PCI
Yenta TI: socket 0000:01:03.0, mfunc 0x000c1002, devctl 0x44
Yenta TI: socket 0000:01:03.0 probing PCI interrupt failed, trying to fix
Yenta TI: socket 0000:01:03.0 no PCI interrupts. Fish. Please report.
Yenta: ISA IRQ mask 0x0000, PCI irq 0
Socket status: 00000000

Output from 2.4.28:

Yenta ISA IRQ mask 0x00d0, PCI irq 3
Socket status: 30000020

Output from "lspci -vn":
[snip]
0000:01:03.0 Class 0607: 104c:ac50 (rev 02)
        Subsystem: 1584:3200
        Flags: bus master, medium devsel, latency 168, IRQ 3
        Memory at 7e001000 (32-bit, non-prefetchable)
        Bus: primary=01, secondary=02, subordinate=05, sec-latency=176
        Memory window 0: 7e400000-7e7ff000 (prefetchable)
        Memory window 1: 7e800000-7ebff000
        I/O window 0: 00004000-000040ff
        I/O window 1: 00004400-000044ff
        16-bit legacy interface ports at 0001
[snip]

Let me know how to proceed, full dmesg output, non-numeric lspci etc.

Thanks!

/ magnus