Re: typo in raid[456] kernel code/no change based on type?

[Justin Piszcz <jpiszcz@lucidpixels.com>]

On Wed, 12 Nov 2008, Justin Piszcz wrote:

> $ cat /proc/mdstat Personalities : [raid1] [raid6] [raid5] [raid4] md1 : 
> active raid1 sdb2[1] sda2[0]
>      136448 blocks [2/2] [UU]
>
> md2 : active raid1 sdb3[1] sda3[0]
>      276109056 blocks [2/2] [UU]
>
> md3 : active raid6 sdj1[10] sdc1[4] sdl1[8] sdk1[1] sdi1[9] sdh1[7] sdg1[6] 
> sdf1[3] sde1[2] sdd1[0]
>      2344263680 blocks level 6, 1024k chunk, algorithm 2 [10/9] [UUUUU_UUUU]
>      [===================>.]  recovery = 99.1% (290466636/293032960) 
> finish=0.6min speed=67979K/sec
>
> md0 : active raid1 sdb1[1] sda1[0]
>      16787776 blocks [2/2] [UU]
>
> unused devices: <none>
>
> --
>
> But in the kernel logs:
>
> [ 3497.577716] md: recovery of RAID array md3
> [ 3497.577720] md: minimum _guaranteed_  speed: 1000 KB/sec/disk.
> [ 3497.577721] md: using maximum available idle IO bandwidth (but not more 
> than 90000 KB/sec) for recovery.
> [ 3497.577728] md: using 128k window, over a total of 293032960 blocks.
> [ 6981.488528] md: md3: recovery done.
> [ 6982.273208] RAID5 conf printout:
>               ^^^^^
> [ 6982.273215]  --- rd:10 wd:10
> [ 6982.273219]  disk 0, o:1, dev:sdd1
> [ 6982.273223]  disk 1, o:1, dev:sdk1
> [ 6982.273227]  disk 2, o:1, dev:sde1
> [ 6982.273231]  disk 3, o:1, dev:sdf1
> [ 6982.273245]  disk 4, o:1, dev:sdc1
> [ 6982.273258]  disk 5, o:1, dev:sdj1
> [ 6982.273260]  disk 6, o:1, dev:sdg1
> [ 6982.273263]  disk 7, o:1, dev:sdh1
> [ 6982.273265]  disk 8, o:1, dev:sdl1
> [ 6982.273267]  disk 9, o:1, dev:sdi1
>
> Is the type detectable via auto-assemble, if it is shouldn't it print out
> the right raid type in the logs/dmesg?
>
> Justin.
>
>

Forgot to cc linux-raid.