Re: [PATCH v2 2/2] iio: light: vcnl4000: add shared IRQ support

[Tsz Shan Chan <tsz.chan.dev@gmail.com>]

On Mon, Aug 24, 2026 at 11:24:26AM +0300, Andy Shevchenko wrote:
> On Sat, Aug 22, 2026 at 03:25:50AM +0100, Jonathan Cameron wrote:
> > On Fri, 14 Aug 2026 14:30:43 +1000
> > Tsz Shan Chan <tsz.chan.dev@gmail.com> wrote:
> 
> > > The INT output of vcnl4010/4020 and vcnl4040/4200 is open drain active
> > > low which can be shared with other devices.
> > > Add IRQF_SHARED and switch the trigger type from IRQF_TRIGGER_FALLING to
> > > IRQF_TRIGGER_LOW. Edge triggering can miss interrupts on a shared line.
> > Fairly low risk change but I guess we'll see.
> > 
> > It used to be annoyingly common for interrupt controllers to support
> > only edge based interrupts, but hopefully that silliness is a thing
> > of the past.
> > 
> > So crossed fingers, I'll apply this and see if we get anyone shouting.
> > I think we'll get away with it
> 
> In another thread somebody mentioned a type of the signal that HW generates.
> Having OD output doesn't prevent HW to behave like it does edge interrupts,
> id est generating a pulse instead of keeping the level until it gets acked.
> With that being said, I would ask the datasheet citation to clarify the case.
> 

vcnl4010/4020 datasheet, Page 11 Table 15 Notes:
  "Once an interrupt is generated the corresponding status bit goes to 1
  and stays there unless it is cleared by writing a 1 in the
  corresponding bit. The int pad will be pulled down while at least one
  of the status bit is 1."

vcnl4040/4200 datasheet, Page 13 Section Interrupt Flag:
  "INT_Flag represents all of the interrupt trigger statuses for ALS and
  PS. If any of these flags trigger from "0" to "1", the INT pin will be
  pulled low. Once the host reads INT_Flag register, all the flags are
  cleared (reset to "0"), and the INT pin is reset to high."

The interrupt is latched. The line stays low until the driver clears it.