Re: [RFC 04/14] x86/apic: Initialize APIC backing page for Secure AVIC

[Neeraj Upadhyay <Neeraj.Upadhyay@amd.com>]

On 11/12/2024 4:13 AM, Melody (Huibo) Wang wrote:
> Hi Neeraj,
> 
> On 9/13/2024 4:36 AM, Neeraj Upadhyay wrote:
> 
>> +static void init_backing_page(void *backing_page)
>> +{
>> +	u32 val;
>> +	int i;
>> +
>> +	val = read_msr_from_hv(APIC_LVR);
>> +	set_reg(backing_page, APIC_LVR, val);
>> +
> 
> When you read the register from hypervisor, there is certain value defined in APM Table 16-2. APIC Registers, says APIC_LVR has value 80??0010h out of reset.
> > More specifically, Bit 31 is set which means the presence of extended APIC registers, and Bit 4 is set which is part of version number: "The local APIC implementation is identified with a value=1Xh (20h-FFh are
> reserved)".
> 
> I think you should verify those values instead of just reading from the hypervisor. Also, I think you probably should verify all of registers you read from the hypervisor before you use them in the guest. In other words, sanitize the inputs from the hypervisor. 
> 

Ok, I will add this verification of hv read data (wherever applicable) as incremental patches.


- Neeraj

> Thanks,
> Melody