[PATCH RESEND 1/5] Bluetooth: btmtksdio: Fix kernel oops in btmtksdio_interrupt

[PATCH RESEND 1/5] Bluetooth: btmtksdio: Fix kernel oops in btmtksdio_interrupt

[sean.wang]

From: Yake Yang <yake.yang@mediatek.com>

Fix the following kernel oops in btmtksdio_interrrupt

[   14.339134]  btmtksdio_interrupt+0x28/0x54
[   14.339139]  process_sdio_pending_irqs+0x68/0x1a0
[   14.339144]  sdio_irq_work+0x40/0x70
[   14.339154]  process_one_work+0x184/0x39c
[   14.339160]  worker_thread+0x228/0x3e8
[   14.339168]  kthread+0x148/0x3ac
[   14.339176]  ret_from_fork+0x10/0x30

That happened because hdev->power_on is already called before
sdio_set_drvdata which btmtksdio_interrupt handler relies on is not
properly set up.

The details are shown as the below: hci_register_dev would run
queue_work(hdev->req_workqueue, &hdev->power_on) as WQ_HIGHPRI
workqueue_struct to complete the power-on sequeunce and thus hci_power_on
may run before sdio_set_drvdata is done in btmtksdio_probe.

The hci_dev_do_open in hci_power_on would initialize the device and enable
the interrupt and thus it is possible that btmtksdio_interrupt is being
called right before sdio_set_drvdata is filled out.

When btmtksdio_interrupt is being called and sdio_set_drvdata is not filled
, the kernel oops is going to happen because btmtksdio_interrupt access an
uninitialized pointer.

Fixes: 9aebfd4a2200 ("Bluetooth: mediatek: add support for MediaTek MT7663S and MT7668S SDIO devices")
Reviewed-by: Mark Chen <markyawenchen@gmail.com>
Co-developed-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Yake Yang <yake.yang@mediatek.com>
---
 drivers/bluetooth/btmtksdio.c | 4 ++--
 1 file changed, 2 insertions(+), 2 deletions(-)

diff --git a/drivers/bluetooth/btmtksdio.c b/drivers/bluetooth/btmtksdio.c
index df3f9d090529..9644069cecbb 100644
--- a/drivers/bluetooth/btmtksdio.c
+++ b/drivers/bluetooth/btmtksdio.c
@@ -1281,6 +1281,8 @@ static int btmtksdio_probe(struct sdio_func *func,
 	hdev->manufacturer = 70;
 	set_bit(HCI_QUIRK_NON_PERSISTENT_SETUP, &hdev->quirks);
 
+	sdio_set_drvdata(func, bdev);
+
 	err = hci_register_dev(hdev);
 	if (err < 0) {
 		dev_err(&func->dev, "Can't register HCI device\n");
@@ -1288,8 +1290,6 @@ static int btmtksdio_probe(struct sdio_func *func,
 		return err;
 	}
 
-	sdio_set_drvdata(func, bdev);
-
 	/* pm_runtime_enable would be done after the firmware is being
 	 * downloaded because the core layer probably already enables
 	 * runtime PM for this func such as the case host->caps &
-- 
2.25.1

[PATCH RESEND 2/5] Bluetooth: mt7921s: Set HCI_QUIRK_VALID_LE_STATES

[sean.wang]

From: Yake Yang <yake.yang@mediatek.com>

The patch set HCI_QUIRK_VALID_LE_STATES to be consistent with the btusb for
MT7921 and is required for the likes of experimental LE simultaneous roles.

Reviewed-by: Mark Chen <markyawenchen@gmail.com>
Co-developed-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Yake Yang <yake.yang@mediatek.com>
---
 drivers/bluetooth/btmtksdio.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/bluetooth/btmtksdio.c b/drivers/bluetooth/btmtksdio.c
index 9644069cecbb..034e55278c56 100644
--- a/drivers/bluetooth/btmtksdio.c
+++ b/drivers/bluetooth/btmtksdio.c
@@ -1070,6 +1070,9 @@ static int btmtksdio_setup(struct hci_dev *hdev)
 			}
 		}
 
+		/* Valid LE States quirk for MediaTek 7921 */
+		set_bit(HCI_QUIRK_VALID_LE_STATES, &hdev->quirks);
+
 		break;
 	case 0x7663:
 	case 0x7668:
-- 
2.25.1

[PATCH RESEND 3/5] Bluetooth: mt7921s: Add .get_data_path_id

[sean.wang]

From: Yake Yang <yake.yang@mediatek.com>

Add .get_data_path_id to fetch data_path_id for MT7921 to support HFP
offload use case.

This is a preliminary patch to add the WBS support to the MT7921 driver.

Reviewed-by: Mark Chen <markyawenchen@gmail.com>
Co-developed-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Yake Yang <yake.yang@mediatek.com>
---
 drivers/bluetooth/btmtksdio.c | 15 ++++++++++++++-
 1 file changed, 14 insertions(+), 1 deletion(-)

diff --git a/drivers/bluetooth/btmtksdio.c b/drivers/bluetooth/btmtksdio.c
index 034e55278c56..4000a994fe2c 100644
--- a/drivers/bluetooth/btmtksdio.c
+++ b/drivers/bluetooth/btmtksdio.c
@@ -936,6 +936,13 @@ static int btmtksdio_mtk_reg_write(struct hci_dev *hdev, u32 reg, u32 val, u32 m
 	return err;
 }
 
+static int btmtksdio_get_data_path_id(struct hci_dev *hdev, __u8 *data_path_id)
+{
+	/* uses 1 as data path id for all the usecases */
+	*data_path_id = 1;
+	return 0;
+}
+
 static int btmtksdio_sco_setting(struct hci_dev *hdev)
 {
 	const struct btmtk_sco sco_setting = {
@@ -968,7 +975,13 @@ static int btmtksdio_sco_setting(struct hci_dev *hdev)
 		return err;
 
 	val |= 0x00000101;
-	return btmtksdio_mtk_reg_write(hdev, MT7921_PINMUX_1, val, ~0);
+	err =  btmtksdio_mtk_reg_write(hdev, MT7921_PINMUX_1, val, ~0);
+	if (err < 0)
+		return err;
+
+	hdev->get_data_path_id = btmtksdio_get_data_path_id;
+
+	return err;
 }
 
 static int btmtksdio_reset_setting(struct hci_dev *hdev)
-- 
2.25.1

[PATCH RESEND 4/5] Bluetooth: mt7921s: Add .btmtk_get_codec_config_data

[sean.wang]

From: Yake Yang <yake.yang@mediatek.com>

add .btmtk_get_codec_config_data to get codec configuration data.

In HFP offload usecase, controllers need to be set codec details before
opening SCO. This callback function is used to fetch vendor specific codec
config data.

This is a preliminary patch to add the WBS support to the MT7921 driver.

Reviewed-by: Mark Chen <markyawenchen@gmail.com>
Co-developed-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Yake Yang <yake.yang@mediatek.com>
---
 drivers/bluetooth/btmtksdio.c | 50 +++++++++++++++++++++++++++++++++++
 1 file changed, 50 insertions(+)

diff --git a/drivers/bluetooth/btmtksdio.c b/drivers/bluetooth/btmtksdio.c
index 4000a994fe2c..c28eb9fc6176 100644
--- a/drivers/bluetooth/btmtksdio.c
+++ b/drivers/bluetooth/btmtksdio.c
@@ -943,6 +943,55 @@ static int btmtksdio_get_data_path_id(struct hci_dev *hdev, __u8 *data_path_id)
 	return 0;
 }
 
+static int btmtksdio_get_codec_config_data(struct hci_dev *hdev,
+					   __u8 link, struct bt_codec *codec,
+					   __u8 *ven_len, __u8 **ven_data)
+{
+	int err = 0;
+
+	if (!ven_data || !ven_len)
+		return -EINVAL;
+
+	*ven_len = 0;
+	*ven_data = NULL;
+
+	if (link != ESCO_LINK) {
+		bt_dev_err(hdev, "Invalid link type(%u)", link);
+		return -EINVAL;
+	}
+
+	*ven_data = kmalloc(sizeof(__u8), GFP_KERNEL);
+	if (!ven_data) {
+		err = -ENOMEM;
+		goto error;
+	}
+
+	/* supports only CVSD and mSBC offload codecs */
+	switch (codec->id) {
+	case 0x02:
+		**ven_data = 0x00;
+		break;
+	case 0x05:
+		**ven_data = 0x01;
+		break;
+	default:
+		err = -EINVAL;
+		bt_dev_err(hdev, "Invalid codec id(%u)", codec->id);
+		goto error;
+	}
+	/* codec and its capabilities are pre-defined to ids
+	 * preset id = 0x00 represents CVSD codec with sampling rate 8K
+	 * preset id = 0x01 represents mSBC codec with sampling rate 16K
+	 */
+	*ven_len = sizeof(__u8);
+	return err;
+
+error:
+	kfree(*ven_data);
+	*ven_data = NULL;
+	return err;
+}
+
 static int btmtksdio_sco_setting(struct hci_dev *hdev)
 {
 	const struct btmtk_sco sco_setting = {
@@ -980,6 +1029,7 @@ static int btmtksdio_sco_setting(struct hci_dev *hdev)
 		return err;
 
 	hdev->get_data_path_id = btmtksdio_get_data_path_id;
+	hdev->get_codec_config_data = btmtksdio_get_codec_config_data;
 
 	return err;
 }
-- 
2.25.1

[PATCH RESEND 5/5] Bluetooth: mt7921s: Add WBS support

[sean.wang]

From: Yake Yang <yake.yang@mediatek.com>

It is time to add wide band speech (WBS) support.

Reviewed-by: Mark Chen <markyawenchen@gmail.com>
Co-developed-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Sean Wang <sean.wang@mediatek.com>
Signed-off-by: Yake Yang <yake.yang@mediatek.com>
---
 drivers/bluetooth/btmtksdio.c | 3 +++
 1 file changed, 3 insertions(+)

diff --git a/drivers/bluetooth/btmtksdio.c b/drivers/bluetooth/btmtksdio.c
index c28eb9fc6176..f3dc5881fff7 100644
--- a/drivers/bluetooth/btmtksdio.c
+++ b/drivers/bluetooth/btmtksdio.c
@@ -1123,6 +1123,9 @@ static int btmtksdio_setup(struct hci_dev *hdev)
 			return err;
 		}
 
+		/* Enable WBS with mSBC codec */
+		set_bit(HCI_QUIRK_WIDEBAND_SPEECH_SUPPORTED, &hdev->quirks);
+
 		/* Enable GPIO reset mechanism */
 		if (bdev->reset) {
 			err = btmtksdio_reset_setting(hdev);
-- 
2.25.1