Re: [EXTERNAL] Re: [PATCH] misc: mrvl-cn10k-dpi: resolve compilation issues on 32-bit ARM

["Arnd Bergmann" <arnd@arndb.de>]

On Wed, Jul 17, 2024, at 14:17, Vamsi Krishna Attunuru wrote:
>>
>>On Wed, Jul 17, 2024, at 13: 45, Vamsi Krishna Attunuru wrote: > > Neither of
>>them worked in our case, HW folks also confirmed that only > 64bit access
>>work correctly. > I will just include the header that address the compilation
>>
>>On Wed, Jul 17, 2024, at 13:45, Vamsi Krishna Attunuru wrote:
>>>
>>> Neither of them worked in our case, HW folks also confirmed that only
>>> 64bit access work correctly.
>>> I will just include the header that address the compilation errors
>>> with ARCH=arm, anyways nobody will use this driver on 32-bit kernel.
>>
>>Please just use a Kconfig dependency then. If the device requires 64-bit
>>register access, then the driver should not use the fallback.
>
> Ack, since it needs to skip compilation on 32-bit platforms, can you please
> confirm below change is suffice or not.
>
> --- a/drivers/misc/Kconfig
> +++ b/drivers/misc/Kconfig
> @@ -588,7 +588,7 @@ config NSM
>  config MARVELL_CN10K_DPI
>         tristate "Octeon CN10K DPI driver"
>         depends on PCI
> -       depends on ARCH_THUNDER || COMPILE_TEST
> +       depends on (ARCH_THUNDER || COMPILE_TEST) && 64BIT
>         help
>

Yes, this is correct, thanks!

I would probably put the 64BIT dependency in a separate
line, or next to the PCI one, but the result is the same,
so pick whichever makes most sense to you.

     Arnd